On Thu, 22 Aug 2024, Mario Limonciello wrote: > From: Mario Limonciello <mario.limonciello@xxxxxxx> > > It is reported that USB4 routers and downstream devices may behave > incorrectly if a dock cable is plugged in at approximately the time that > the autosuspend_delay is configured. In this situation the device has > attempted to enter D3cold, but didn't finish D3cold entry when the PCI > core tried to transition it back to D0. > > Empirically measuring this situation an "aborted" D3cold exit takes > ~60ms and a "normal" D3cold exit takes ~6ms. > > The PCI-PM 1.2 spec specifies that the restore time for functions > in D3cold is either 'Full context restore or boot latency'. > > As PCIe r6.0 sec 5.8 specifies that the device will have gone > through a conventional reset, it may take some time for the > device to be ready. > > Wait up to 1 sec as specified in PCIe r6.0 sec 6.6.1 for a device > in D3cold to return to D0. > > Reviewed-by: Ilpo Järvinen <ilpo.jarvinen@xxxxxxxxxxxxxxx> > Signed-off-by: Mario Limonciello <mario.limonciello@xxxxxxx> > --- > drivers/pci/pci.c | 11 +++++++++++ > drivers/pci/pci.h | 1 + > 2 files changed, 12 insertions(+) > > diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c > index b7717155e2fd0..7e861b6923d0a 100644 > --- a/drivers/pci/pci.c > +++ b/drivers/pci/pci.c > @@ -1425,6 +1425,17 @@ int pci_power_up(struct pci_dev *dev) > else if (state == PCI_D2) > udelay(PCI_PM_D2_DELAY); > > + /* > + * D3cold -> D0 will have gone through a conventional reset and may need > + * time to be ready. > + */ > + if (dev->current_state == PCI_D3cold) { > + int ret; > + > + ret = pci_dev_wait(dev, PCI_DEV_WAIT_D3COLD_D0, PCI_RESET_WAIT); > + if (ret) > + return ret; > + } > end: > dev->current_state = PCI_D0; > if (need_restore) > diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h > index 477257e843952..a675f5d55f298 100644 > --- a/drivers/pci/pci.h > +++ b/drivers/pci/pci.h > @@ -11,6 +11,7 @@ enum pci_reset_type { > PCI_DEV_WAIT_BUS_RESET, > PCI_DEV_WAIT_RESUME, > PCI_DEV_WAIT_DPC, > + PCI_DEV_WAIT_D3COLD_D0, Don't you need to add a string for this too? :-/ I wonder if it would be prudent to add PCI_DEV_WAIT_MAX and use static_assert() for the sizeof the pci_reset_types[] in patch 1 to autodetect mismatch (though it won't help if something is added in the middle of the list). -- i.