Re: [PATCH 2/2] arm64: dts: qcom: x1e80100: Add USB Multiport controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 





On 8/14/2024 6:24 PM, Konrad Dybcio wrote:
On 14.08.2024 12:08 PM, Song Xue wrote:

On 8/9/2024 9:18 PM, Konrad Dybcio wrote:
X1E80100 has a multiport controller with 2 HS (eUSB) and 2 SS PHYs
attached to it. It's commonly used for USB-A ports and internally
routed devices. Configure it to support such functionality.

Signed-off-by: Konrad Dybcio<konrad.dybcio@xxxxxxxxxx>
---

[...]

+
+                phys = <&usb_mp_hsphy0>, <&usb_mp_qmpphy0>,
+                       <&usb_mp_hsphy1>, <&usb_mp_qmpphy1>;
+                phy-names = "usb2-0", "usb3-0",
+                        "usb2-1", "usb3-1";
+                dr_mode = "host";

Why do we add the dr_mode definition in dtsi file rather than in corresponding board dts file?  Could we follow the node "usb_1_ss1_dwc3"  in x1e80100-crd.dtsi?

That is because the MP controller is host-only and it doesn't make sense
to ensure the OS of that in each board file separately. That's also how
it's done on other platforms with a MP controller description.


BTW, how do we verify the function of  multiport controller?From my test on x1e80100-crd,  the eusb6 which is from usb_mp_hsphy1 attaches the third-party repeater, do we need a new repeater node/driver to verify the function of eusb6?

I have a X1E Surface Laptop 7 with a USB-A port with a NXP PTN3222 in
front of it. Tested with a smoke test, with both SS and HS USB-A devices.

What is detailed information on smoke test.
From my end, I also have two questions.
1. I found the usb_mp_hsphy1 is using the driver "phy-qcom-snps-eusb2". However, the driver requires a repeater node from DT. At present, we don't have the node or driver for NXP repeater and it is not working on eusb6 to detect the NXP repeater. So, is it possible for us to have complete function involving with MP DT and repeater node for CRD board, and then we push patches together? 2. The usb_mp_dwc3 node has four phys. When enabling the driver for the node, we must need enable all four phys in borad's DT. Howerver, if the board is only using one phy like eusb6, is it suitable to enable other three phys?

Regards,
Song Xue
Konrad




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux