On 21.8.2023 9.57, Basavaraj Natikar wrote:
Use the low-power states of the underlying platform to enable runtime PM.
If the platform doesn't support runtime D3, then enabling default RPM will
result in the controller malfunctioning, as in the case of hotplug devices
not being detected because of a failed interrupt generation.
Cc: Mario Limonciello <mario.limonciello@xxxxxxx>
Signed-off-by: Basavaraj Natikar <Basavaraj.Natikar@xxxxxxx>
---
drivers/usb/host/xhci-pci.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index c908a80ef436..1bb5b510c5ba 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -693,7 +693,9 @@ static int xhci_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
/* USB-2 and USB-3 roothubs initialized, allow runtime pm suspend */
pm_runtime_put_noidle(&dev->dev);
- if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
+ if (pci_choose_state(dev, PMSG_SUSPEND) == PCI_D0)
+ pm_runtime_forbid(&dev->dev);
+ else if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
pm_runtime_allow(&dev->dev);
dma_set_max_seg_size(&dev->dev, UINT_MAX);
Looks good to me
-Mathias
