Use read_poll_timeout() instead of open coding it.
In the same time, fix the typo in the error message.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
drivers/usb/musb/tusb6010.c | 17 +++++++----------
1 file changed, 7 insertions(+), 10 deletions(-)
diff --git a/drivers/usb/musb/tusb6010.c b/drivers/usb/musb/tusb6010.c
index cbc707fe570f..2ae82e049f88 100644
--- a/drivers/usb/musb/tusb6010.c
+++ b/drivers/usb/musb/tusb6010.c
@@ -21,6 +21,7 @@
#include <linux/usb.h>
#include <linux/irq.h>
#include <linux/io.h>
+#include <linux/iopoll.h>
#include <linux/device.h>
#include <linux/platform_device.h>
#include <linux/dma-mapping.h>
@@ -1029,7 +1030,7 @@ static int tusb_musb_start(struct musb *musb)
void __iomem *tbase = musb->ctrl_base;
unsigned long flags;
u32 reg;
- int i;
+ int ret;
/*
* Enable or disable power to TUSB6010. When enabling, turn on 3.3 V and
@@ -1037,17 +1038,13 @@ static int tusb_musb_start(struct musb *musb)
* provide then PGOOD signal to TUSB6010 which will release it from reset.
*/
gpiod_set_value(glue->enable, 1);
- msleep(1);
/* Wait for 100ms until TUSB6010 pulls INT pin down */
- i = 100;
- while (i && gpiod_get_value(glue->intpin)) {
- msleep(1);
- i--;
- }
- if (!i) {
- pr_err("tusb: Powerup respones failed\n");
- return -ENODEV;
+ ret = read_poll_timeout(gpiod_get_value, reg, !reg, 1000, 100000, true,
+ glue->intpin);
+ if (ret) {
+ pr_err("tusb: Powerup response failed\n");
+ return ret;
}
spin_lock_irqsave(&musb->lock, flags);
--
2.40.0.1.gaa8946217a0b
