Re: [PATCH v4 13/18] phy: qcom-qmp: Register as a typec switch for orientation detection

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

On 18/03/2023 13:18, Bryan O'Donoghue wrote:
From: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

The lane select switch for USB typec orientation is within the USB QMP PHY.
the current device.  It could be connected through an endpoint, to an
independent device handling the typec detection, ie the QCOM SPMI typec
driver.

bod: Fixed the logic qcom_qmp_phy_typec_switch_set() to disable phy
  on disconnect if and only if we have initialized the PHY.
  Retained CC orientation logic in qcom_qmp_phy_com_init() to simplify
  patch.

bod: Ported from earlier version of driver to phy-qcom-qmp-combo.c

Co-developed-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
Signed-off-by: Wesley Cheng <wcheng@xxxxxxxxxxxxxx>
Co-developed-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
---
  drivers/phy/qualcomm/Kconfig              |  8 +++
  drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 80 +++++++++++++++++++++--
  2 files changed, 84 insertions(+), 4 deletions(-)

diff --git a/drivers/phy/qualcomm/Kconfig b/drivers/phy/qualcomm/Kconfig
index 4850d48f31fa1..8240fffdbed4e 100644
--- a/drivers/phy/qualcomm/Kconfig
+++ b/drivers/phy/qualcomm/Kconfig
@@ -101,6 +101,14 @@ config PHY_QCOM_QMP_USB
endif # PHY_QCOM_QMP +config PHY_QCOM_QMP_TYPEC
+	def_bool PHY_QCOM_QMP=y && TYPEC=y || PHY_QCOM_QMP=m && TYPEC
+	help
+	  Register a type C switch from the QMP PHY driver for type C
+	  orientation support.  This has dependencies with if the type C kernel
+	  configuration is enabled or not.  This support will not be present if
+	  USB type C is disabled.

Is there a reason to only enable the TypeC logic with a config ?

If unlinked from DT it won't be used, so no need to add a new config for that.

Neil

+
  config PHY_QCOM_QUSB2
  	tristate "Qualcomm QUSB2 PHY Driver"
  	depends on OF && (ARCH_QCOM || COMPILE_TEST)
diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
index c1483e157af4a..afe708c63557d 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-combo.c
@@ -19,6 +19,7 @@
  #include <linux/regulator/consumer.h>
  #include <linux/reset.h>
  #include <linux/slab.h>
+#include <linux/usb/typec_mux.h>
#include <dt-bindings/phy/phy-qcom-qmp.h> @@ -63,6 +64,10 @@
  /* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */
  #define CLAMP_EN				BIT(0) /* enables i/o clamp_n */
+/* QPHY_V3_DP_COM_TYPEC_CTRL register bits */
+#define SW_PORTSELECT_VAL			BIT(0)
+#define SW_PORTSELECT_MUX			BIT(1)
+
  #define PHY_INIT_COMPLETE_TIMEOUT		10000
struct qmp_phy_init_tbl {
@@ -1323,6 +1328,9 @@ struct qmp_combo {
  	struct clk_fixed_rate pipe_clk_fixed;
  	struct clk_hw dp_link_hw;
  	struct clk_hw dp_pixel_hw;
+
+	struct typec_switch_dev *sw;
+	enum typec_orientation orientation;
  };
static void qmp_v3_dp_aux_init(struct qmp_combo *qmp);
@@ -1970,7 +1978,8 @@ static void qmp_v3_configure_dp_tx(struct qmp_combo *qmp)
  static bool qmp_combo_configure_dp_mode(struct qmp_combo *qmp)
  {
  	u32 val;
-	bool reverse = false;
+	bool reverse = qmp->orientation == TYPEC_ORIENTATION_REVERSE;
+	const struct phy_configure_opts_dp *dp_opts = &qmp->dp_opts;
val = DP_PHY_PD_CTL_PWRDN | DP_PHY_PD_CTL_AUX_PWRDN |
  	      DP_PHY_PD_CTL_PLL_PWRDN | DP_PHY_PD_CTL_DP_CLAMP_EN;
@@ -1989,10 +1998,18 @@ static bool qmp_combo_configure_dp_mode(struct qmp_combo *qmp)
  	 * if (orientation == ORIENTATION_CC2)
  	 *	writel(0x4c, qmp->dp_dp_phy + QSERDES_V3_DP_PHY_MODE);
  	 */
+	if (dp_opts->lanes == 4 || reverse)
+		val |= DP_PHY_PD_CTL_LANE_0_1_PWRDN;
+	if (dp_opts->lanes == 4 || !reverse)
+		val |= DP_PHY_PD_CTL_LANE_2_3_PWRDN;
+
  	val |= DP_PHY_PD_CTL_LANE_2_3_PWRDN;
  	writel(val, qmp->dp_dp_phy + QSERDES_DP_PHY_PD_CTL);
- writel(0x5c, qmp->dp_dp_phy + QSERDES_DP_PHY_MODE);
+	if (reverse)
+		writel(0x4c, qmp->pcs + QSERDES_DP_PHY_MODE);
+	else
+		writel(0x5c, qmp->pcs + QSERDES_DP_PHY_MODE);
return reverse;
  }
@@ -2476,6 +2493,7 @@ static int qmp_combo_com_init(struct qmp_combo *qmp)
  {
  	const struct qmp_phy_cfg *cfg = qmp->cfg;
  	void __iomem *com = qmp->com;
+	u32 val;
  	int ret;
mutex_lock(&qmp->phy_mutex);
@@ -2513,8 +2531,11 @@ static int qmp_combo_com_init(struct qmp_combo *qmp)
  			SW_DPPHY_RESET_MUX | SW_DPPHY_RESET |
  			SW_USB3PHY_RESET_MUX | SW_USB3PHY_RESET);
- /* Default type-c orientation, i.e CC1 */
-	qphy_setbits(com, QPHY_V3_DP_COM_TYPEC_CTRL, 0x02);
+	/* Latch CC orientation based on reported state by TCPM */
+	val = SW_PORTSELECT_MUX;
+	if (qmp->orientation == TYPEC_ORIENTATION_REVERSE)
+		val |= SW_PORTSELECT_VAL;
+	qphy_setbits(com, QPHY_V3_DP_COM_TYPEC_CTRL, val);
qphy_setbits(com, QPHY_V3_DP_COM_PHY_MODE_CTRL, USB3_MODE | DP_MODE); @@ -3353,6 +3374,53 @@ static struct phy *qmp_combo_phy_xlate(struct device *dev, struct of_phandle_arg
  	return ERR_PTR(-EINVAL);
  }
+#if IS_ENABLED(CONFIG_PHY_QCOM_QMP_TYPEC)
+static int qmp_combo_typec_switch_set(struct typec_switch_dev *sw,
+				      enum typec_orientation orientation)
+{
+	struct qmp_combo *qmp = typec_switch_get_drvdata(sw);
+	struct phy *dp_phy = qmp->dp_phy;
+	int ret = 0;
+
+	dev_dbg(qmp->dev, "Toggling orientation current %d requested %d\n",
+		qmp->orientation, orientation);
+
+	qmp->orientation = orientation;
+
+	if (orientation == TYPEC_ORIENTATION_NONE) {
+		if (qmp->init_count)
+			ret = qmp_combo_dp_power_off(dp_phy);
+	} else {
+		if (!qmp->init_count)
+			ret = qmp_combo_dp_power_on(dp_phy);
+	}
+
+	return 0;
+}
+
+static int qmp_combo_typec_switch_register(struct qmp_combo *qmp)
+{
+	struct typec_switch_desc sw_desc;
+	struct device *dev = qmp->dev;
+
+	sw_desc.drvdata = qmp;
+	sw_desc.fwnode = dev->fwnode;
+	sw_desc.set = qmp_combo_typec_switch_set;
+	qmp->sw = typec_switch_register(dev, &sw_desc);
+	if (IS_ERR(qmp->sw)) {
+		dev_err(dev, "Error registering typec switch: %ld\n",
+			PTR_ERR(qmp->sw));
+	}
+
+	return 0;
+}
+#else
+static int qmp_combo_typec_switch_register(struct qmp_combo *qmp)
+{
+	return 0;
+}
+#endif
+
  static int qmp_combo_probe(struct platform_device *pdev)
  {
  	struct qmp_combo *qmp;
@@ -3443,6 +3511,10 @@ static int qmp_combo_probe(struct platform_device *pdev)
  	else
  		phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
+ ret = qmp_combo_typec_switch_register(qmp);
+	if (ret)
+		goto err_node_put;
+
  	of_node_put(usb_np);
  	of_node_put(dp_np);




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux