Move the LAN7800 internal phy (phy ID 0x0007c132) specific register accesses to the phy driver (microchip.c).
Fixes: 14437e3fa284f465dbbc8611fd4331ca8d60e986 ("lan78xx: workaround of forced 100 Full/Half duplex mode error")
Signed-off-by: Yuiko Oshino <yuiko.oshino@xxxxxxxxxxxxx>
---
drivers/net/usb/lan78xx.c | 27 +--------------------------
1 file changed, 1 insertion(+), 26 deletions(-)
diff --git a/drivers/net/usb/lan78xx.c b/drivers/net/usb/lan78xx.c
index f18ab8e220db..068488890d57 100644
--- a/drivers/net/usb/lan78xx.c
+++ b/drivers/net/usb/lan78xx.c
@@ -2115,33 +2115,8 @@ static void lan78xx_remove_mdio(struct lan78xx_net *dev)
static void lan78xx_link_status_change(struct net_device *net)
{
struct phy_device *phydev = net->phydev;
- int temp;
-
- /* At forced 100 F/H mode, chip may fail to set mode correctly
- * when cable is switched between long(~50+m) and short one.
- * As workaround, set to 10 before setting to 100
- * at forced 100 F/H mode.
- */
- if (!phydev->autoneg && (phydev->speed == 100)) {
- /* disable phy interrupt */
- temp = phy_read(phydev, LAN88XX_INT_MASK);
- temp &= ~LAN88XX_INT_MASK_MDINTPIN_EN_;
- phy_write(phydev, LAN88XX_INT_MASK, temp);
- temp = phy_read(phydev, MII_BMCR);
- temp &= ~(BMCR_SPEED100 | BMCR_SPEED1000);
- phy_write(phydev, MII_BMCR, temp); /* set to 10 first */
- temp |= BMCR_SPEED100;
- phy_write(phydev, MII_BMCR, temp); /* set to 100 later */
-
- /* clear pending interrupt generated while workaround */
- temp = phy_read(phydev, LAN88XX_INT_STS);
-
- /* enable phy interrupt back */
- temp = phy_read(phydev, LAN88XX_INT_MASK);
- temp |= LAN88XX_INT_MASK_MDINTPIN_EN_;
- phy_write(phydev, LAN88XX_INT_MASK, temp);
- }
+ phy_print_status(phydev);
}
static int irq_map(struct irq_domain *d, unsigned int irq,
--
2.17.1
