On 05/01/2023 10:28, Macpaul Lin wrote:
> 1. Enable USB device port (USB port0).
> 2. Enable u2 speed for other USB HOST (USB port1/2/3).
> 3. Configure mt6360 (TYPEC) related pinctrls.
>
> Note: Full dual-role switch capability requires TYPEC MUX driver and dts
> update will be send in separate patches.
>
> Signed-off-by: Macpaul Lin <macpaul.lin@xxxxxxxxxxxx>
> ---
> arch/arm64/boot/dts/mediatek/mt8195-demo.dts | 51 ++++++++++++++++++++
> 1 file changed, 51 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/mediatek/mt8195-demo.dts b/arch/arm64/boot/dts/mediatek/mt8195-demo.dts
> index 07a864cb8b54..207bb5f4c58f 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8195-demo.dts
> +++ b/arch/arm64/boot/dts/mediatek/mt8195-demo.dts
> @@ -12,6 +12,7 @@
> #include <dt-bindings/input/input.h>
> #include <dt-bindings/pinctrl/mt8195-pinfunc.h>
> #include <dt-bindings/regulator/mediatek,mt6360-regulator.h>
> +#include <dt-bindings/usb/pd.h>
>
> / {
> model = "MediaTek MT8195 demo board";
> @@ -380,6 +381,22 @@
> };
> };
>
> + mt6360_pins: mt6360-pins {
> + pins {
> + pinmux = <PINMUX_GPIO100__FUNC_GPIO100>,
> + <PINMUX_GPIO101__FUNC_GPIO101>;
> + input-enable;
> + bias-pull-up;
> + };
> + };
> +
> + u3_p0_vbus: u3_p0vbusdefault {
No underscores in node names. Also does not look correct naming. Please
run `make dtbs_check` (see
Documentation/devicetree/bindings/writing-schema.rst for instructions).
> + pins_cmd_dat {
Same problem.
Best regards,
Krzysztof
