Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx> writes: > Texas Instruments DA8xx/OMAP-L1x OHCI glue layer. > > This OHCI implementation is not without quirks: there's only one physical port > despite the root hub reporting two; the port's power control and over-current > status bits are not connected to any pins, however, at least on the DA830 EVM > board, those signals are connected via GPIO, thus the provision was made for > overriding the OHCI port power and over-current bits at the board level... > > Signed-off-by: Mikhail Cherkashin <mcherkashin@xxxxxxxxxxxxx> > Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx> As far as the plaform stuff (clocks, register acces etc.) are concerned Signed-off-by: Kevin Hilman <khilman@xxxxxxxxxxxxxxxxxxx> > --- > WARNING: the MUSB and OHCI drivers will only work if your boot loader leaves > the DA8xx boot configuration registers unlocked, otherwise they will lock up > the kernel! Should we add something to da8xx init to unlock these if MUSB/OHCI is enabled? Kevin -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
