From: Amelie Delaunay <amelie.delaunay@xxxxxxxxxxx> When using usb-role-switch, D+ pull-up is set as soon as DTCL_SFTDISCON is cleared, whatever the vbus valid signal state is. The pull-up should not be set when vbus isn't present (this is determined by the drd controller). This patch ensures that B-Session (so Peripheral role + vbus valid signal) is valid before clearing the DCTL_SFTDISCON bit when role switch is used. Keep original behavior when usb-role-switch isn't used. Signed-off-by: Amelie Delaunay <amelie.delaunay@xxxxxxxxxxx> Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxxxxxxx> --- drivers/usb/dwc2/gadget.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/usb/dwc2/gadget.c b/drivers/usb/dwc2/gadget.c index fe2a58c758610..8b15742d9e8aa 100644 --- a/drivers/usb/dwc2/gadget.c +++ b/drivers/usb/dwc2/gadget.c @@ -3594,7 +3594,8 @@ void dwc2_hsotg_core_disconnect(struct dwc2_hsotg *hsotg) void dwc2_hsotg_core_connect(struct dwc2_hsotg *hsotg) { /* remove the soft-disconnect and let's go */ - dwc2_clear_bit(hsotg, DCTL, DCTL_SFTDISCON); + if (!hsotg->role_sw || (dwc2_readl(hsotg, GOTGCTL) & GOTGCTL_BSESVLD)) + dwc2_clear_bit(hsotg, DCTL, DCTL_SFTDISCON); } /** -- 2.25.1