Hi Krishna, On Sun, May 08, 2022 at 05:42:25PM +0530, Krishna Kurapati wrote: > From: Sandeep Maheswaram <quic_c_sanm@xxxxxxxxxxx> > > Add device tree bindings for SNPS phy tuning parameters. > > Signed-off-by: Sandeep Maheswaram <quic_c_sanm@xxxxxxxxxxx> > Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx> > --- > .../bindings/phy/qcom,usb-snps-femto-v2.yaml | 87 ++++++++++++++++++++++ > 1 file changed, 87 insertions(+) > > diff --git a/Documentation/devicetree/bindings/phy/qcom,usb-snps-femto-v2.yaml b/Documentation/devicetree/bindings/phy/qcom,usb-snps-femto-v2.yaml > index 1ce251d..6c2ecdd 100644 > --- a/Documentation/devicetree/bindings/phy/qcom,usb-snps-femto-v2.yaml > +++ b/Documentation/devicetree/bindings/phy/qcom,usb-snps-femto-v2.yaml > @@ -53,6 +53,93 @@ properties: > vdda33-supply: > description: phandle to the regulator 3.3V supply node. > <snip> > + > + qcom,hs-rise-fall-time-bps: > + $ref: /schemas/types.yaml#/definitions/int32 > + description: > + This adjusts the rise/fall times of the high-speed waveform. > + The values defined are in multiples of basis points (1bp = 0.01%). > + The hardware accepts only discrete values. The value closest to the > + provided input will be chosen as the override value for this param. > + > + qcom,hs-crossover-voltage: > + $ref: /schemas/types.yaml#/definitions/int32 > + description: > + This adjusts the voltage at which the DP<#> and DM<#> > + signals cross while transmitting in HS mode. > + The values defined are in milli volts. The hardware accepts only > + discrete values. The value closest to the provided input will be > + chosen as the override value for this param. > + > + qcom,hs-output-impedance: > + $ref: /schemas/types.yaml#/definitions/int32 > + description: > + In some applications, there can be significant series resistance > + on the D+ and D- paths between the transceiver and cable. This adjusts > + the driver source impedance to compensate for added series > + resistance on the USB. The values defined are in milliohms. %s/milliohms/mill ohms > + The hardware accepts only discrete values. The value closest to the > + provided input will be chosen as the override value for this param. > + What are the units for HS crossover voltage and output impedence? can you add units as a suffix like other parameters? Thanks, Pavan