Re: [PATCH v8 04/13] phy: tegra: xusb: Rearrange UPHY init on Tegra210

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 25-03-21, 17:40, Thierry Reding wrote:
> From: JC Kuo <jckuo@xxxxxxxxxx>
> 
> This commit is a preparation for enabling XUSB SC7 support.
> It rearranges Tegra210 XUSB PADCTL UPHY initialization sequence,
> for the following reasons:
> 
> 1. PLLE hardware power sequencer has to be enabled only after both
>    PEX UPHY PLL and SATA UPHY PLL are initialized.
>    tegra210_uphy_init() -> tegra210_pex_uphy_enable()
>                         -> tegra210_sata_uphy_enable()
>                         -> tegra210_plle_hw_sequence_start()
>                         -> tegra210_aux_mux_lp0_clamp_disable()
> 
> 2. At cold boot and SC7 exit, the following bits must be cleared after
>    PEX/SATA lanes are out of IDDQ (IDDQ_DISABLE=1).
>    a. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_CLAMP_EN,
>    b. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_CLAMP_EN_EARLY
>    c. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_VCORE_DOWN
> 
>    tegra210_pex_uphy_enable() and tegra210_sata_uphy_enable() are in
>    charge of bringing lanes out of IDDQ, and then AUX_MUX_LP0_* bits
>    will be cleared by tegra210_aux_mux_lp0_clamp_disable().
> 
> 3. Once UPHY PLL hardware power sequencer is enabled, do not assert
>    reset to PEX/SATA PLLs, otherwise UPHY PLL operation will be broken.

Acked-By: Vinod Koul <vkoul@xxxxxxxxxx>

-- 
~Vinod



[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux