Fixes the following W=1 kernel build warning(s):
drivers/net/usb/r8152.c:992: warning: Function parameter or member 'mode_pre' not described in 'fw_phy_nc'
drivers/net/usb/r8152.c:992: warning: Function parameter or member 'mode_post' not described in 'fw_phy_nc'
Cc: "David S. Miller" <davem@xxxxxxxxxxxxx>
Cc: Jakub Kicinski <kuba@xxxxxxxxxx>
Cc: Hayes Wang <hayeswang@xxxxxxxxxxx>
Cc: nic maintainers <nic_swsd@xxxxxxxxxxx>
Cc: linux-usb@xxxxxxxxxxxxxxx
Cc: netdev@xxxxxxxxxxxxxxx
Signed-off-by: Lee Jones <lee.jones@xxxxxxxxxx>
---
drivers/net/usb/r8152.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/usb/r8152.c b/drivers/net/usb/r8152.c
index cebe2dc15c3f0..b9b3d19a2e988 100644
--- a/drivers/net/usb/r8152.c
+++ b/drivers/net/usb/r8152.c
@@ -963,8 +963,8 @@ struct fw_phy_patch_key {
* @patch_en_addr: the register of enabling patch mode. Depends on chip.
* @patch_en_value: patch mode enabled mask. Depends on the firmware.
* @mode_reg: the regitster of switching the mode.
- * @mod_pre: the mode needing to be set before loading the firmware.
- * @mod_post: the mode to be set when finishing to load the firmware.
+ * @mode_pre: the mode needing to be set before loading the firmware.
+ * @mode_post: the mode to be set when finishing to load the firmware.
* @reserved: reserved space (unused)
* @bp_start: the start register of break points. Depends on chip.
* @bp_num: the break point number which needs to be set for this firmware.
--
2.25.1
