On 27/03/2020 00:26, Martin Blumenstingl wrote:
> Hi Neil,
>
> On Thu, Mar 26, 2020 at 2:45 PM Neil Armstrong <narmstrong@xxxxxxxxxxxx> wrote:
> [...]
>> -static int dwc3_meson_g12a_usb2_init(struct dwc3_meson_g12a *priv)
>> +static int dwc3_meson_g12a_usb2_init(struct dwc3_meson_g12a *priv,
>> + enum phy_mode mode)
>> {
>> int i, ret;
>>
>> - if (priv->otg_mode == USB_DR_MODE_PERIPHERAL)
>> - priv->otg_phy_mode = PHY_MODE_USB_DEVICE;
>> - else
>> - priv->otg_phy_mode = PHY_MODE_USB_HOST;
>> -
>> for (i = 0; i < priv->drvdata->num_phys; ++i) {
>> if (!priv->phys[i])
>> continue;
>> @@ -284,9 +286,10 @@ static void dwc3_meson_g12a_usb3_init(struct dwc3_meson_g12a *priv)
>> FIELD_PREP(USB_R1_P30_PCS_TX_SWING_FULL_MASK, 127));
>> }
> There is something strange with dwc3_meson_g12a_usb2_init.
> enum phy_mode mode is added here but it's not used inside this function
You are right...
>
> I also think that we should not pass enum phy_mode to
> dwc3_meson_g12a_usb_otg_apply_mode
> I'm aware that the original function used enum phy_mode inside but
> this doesn't seem right:
> we're not configuring a PHY there
> instead we're setting up the OTG switch so I think we should use enum
> usb_role instead
Indirectly yes, we setup how the phy_mode is set in the glue, and passing
usb_role will need an useless conversion in dwc3_meson_g12a_usb_init_glue
also calling dwc3_meson_g12a_usb_otg_apply_mode.
>
> [...]
> not part of this patch but should be:
> there's a still a direct call to dwc3_meson_g12a_usb_init() in
> dwc3_meson_g12a_resume()
> I think that needs to be changed to priv->drvdata->usb_init(priv); as well
>
Indeed, I'll fix that.
Again, thanks for reviewing !
Neil
