This patch enables the primary USB controller which has - One USB3 SS PHY using gpio-usb-conn - One USB2 HS PHY in device mode only and no connector driver associated. Cc: Andy Gross <agross@xxxxxxxxxx> Cc: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Cc: Rob Herring <robh+dt@xxxxxxxxxx> Cc: Mark Rutland <mark.rutland@xxxxxxx> Cc: linux-arm-msm@xxxxxxxxxxxxxxx Cc: devicetree@xxxxxxxxxxxxxxx Cc: linux-kernel@xxxxxxxxxxxxxxx Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/qcs404-evb.dtsi | 29 ++++++++++++++++++++++++ 1 file changed, 29 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi b/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi index 07d6d793a922..4045d3000da6 100644 --- a/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi +++ b/arch/arm64/boot/dts/qcom/qcs404-evb.dtsi @@ -329,6 +329,35 @@ &usb2_phy_sec { status = "okay"; }; +&usb3 { + status = "okay"; + dwc3@7580000 { + usb-role-switch; + usb_con: connector { + compatible = "gpio-usb-b-connector"; + label = "USB-C"; + id-gpios = <&tlmm 116 GPIO_ACTIVE_HIGH>; + vbus-supply = <&usb3_vbus_reg>; + pinctrl-names = "default"; + pinctrl-0 = <&usb3_id_pin>, <&usb3_vbus_pin>; + status = "okay"; + }; + }; +}; + +&usb2_phy_prim { + vdd-supply = <&vreg_l4_1p2>; + vdda1p8-supply = <&vreg_l5_1p8>; + vdda3p3-supply = <&vreg_l12_3p3>; + status = "okay"; +}; + +&usb3_phy { + vdd-supply = <&vreg_l3_1p05>; + vdda1p8-supply = <&vreg_l5_1p8>; + status = "okay"; +}; + &wifi { status = "okay"; vdd-0.8-cx-mx-supply = <&vreg_l2_1p275>; -- 2.25.0