Up to now the polarity of the over current pin was hard coded to active high. Use the already defined device tree properties to configure polarity on i.MX25, too. In difference to i.MX6/7 use active high behavior if the polarity is unspecified to keep compatibility to existing device trees. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx> --- drivers/usb/chipidea/usbmisc_imx.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+) diff --git a/drivers/usb/chipidea/usbmisc_imx.c b/drivers/usb/chipidea/usbmisc_imx.c index 4a8de1b37f67..47eee5cade84 100644 --- a/drivers/usb/chipidea/usbmisc_imx.c +++ b/drivers/usb/chipidea/usbmisc_imx.c @@ -120,6 +120,14 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data) val &= ~(MX25_OTG_SIC_MASK | MX25_OTG_PP_BIT); val |= (MX25_EHCI_INTERFACE_DIFF_UNI & MX25_EHCI_INTERFACE_MASK) << MX25_OTG_SIC_SHIFT; val |= (MX25_OTG_PM_BIT | MX25_OTG_OCPOL_BIT); + + /* + * If the polarity is not configured assume active high for + * historical reasons. + */ + if (data->oc_pol_configured && data->oc_pol_active_low) + val &= ~MX25_OTG_OCPOL_BIT; + writel(val, usbmisc->base); break; case 1: @@ -129,6 +137,13 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data) val |= (MX25_H1_PM_BIT | MX25_H1_OCPOL_BIT | MX25_H1_TLL_BIT | MX25_H1_USBTE_BIT | MX25_H1_IPPUE_DOWN_BIT); + /* + * If the polarity is not configured assume active high for + * historical reasons. + */ + if (data->oc_pol_configured && data->oc_pol_active_low) + val &= ~MX25_H1_OCPOL_BIT; + writel(val, usbmisc->base); break; -- 2.19.2
