On Tue, Dec 19, 2017 at 05:33:14PM +0000, Alejandro Mery wrote: > Hi Bin, > > On 19/12/17 17:22, Bin Liu wrote: > > Hi Alejandro, > > > > On Fri, Dec 08, 2017 at 07:23:54PM +0000, Alejandro Mery wrote: > >> MUSB's davinci glue was made to depend on BROKEN by Felipe Balbi back in > >> 2013 because of lack of active development. needed changes were actually trivial > >> > >> Fixes: 787f5627bec8 (usb: musb: make davinci and da8xx glues depend on BROKEN) > >> Signed-off-by: Alejandro Mery <amery@xxxxxxxxxxxxxxxxxxx> > > Thanks for the effort to re-enable this driver. But due to lack of > > development, other than the phy and fifo mode which you try to fix with > > these two patches, the driver still doesn't fit in the current driver > > framework, for example, > > > > - the driver depends on mach/ header for CPU and board type; > > - clk control is not separated; > > - gpio control vbus should use extcon driver; > I'll try to fix these issues but it will take a while. I'm still > struggling to get USB working at all on the DM365 EVM Thanks for the effort. > > > > > So I feel it is not ready to un-broken it yet, unless others have > > different opinion. > > > > But I could take these two patches if not remove BROKEN from Kconfig. > > do you want a v2 for that? That will be great! Thanks, -Bin. -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
