From: Thierry Vignaud <tvignaud@xxxxxxxxxxxx> Remove old comments about USB_EHCI_HCD. Cc: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> Acked-by: David Brownell <dbrownell@xxxxxxxxxxxxxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxx> --- drivers/usb/host/Kconfig | 5 +---- 1 files changed, 1 insertions(+), 4 deletions(-) diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig index 2c63bfb..c1cfed7 100644 --- a/drivers/usb/host/Kconfig +++ b/drivers/usb/host/Kconfig @@ -24,10 +24,7 @@ config USB_EHCI_HCD The Enhanced Host Controller Interface (EHCI) is standard for USB 2.0 "high speed" (480 Mbit/sec, 60 Mbyte/sec) host controller hardware. If your USB host controller supports USB 2.0, you will likely want to - configure this Host Controller Driver. At the time of this writing, - the primary implementation of EHCI is a chip from NEC, widely available - in add-on PCI cards, but implementations are in the works from other - vendors including Intel and Philips. Motherboard support is appearing. + configure this Host Controller Driver. EHCI controllers are packaged with "companion" host controllers (OHCI or UHCI) to handle USB 1.1 devices connected to root hub ports. Ports -- 1.6.2 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html