On 2017-03-25 01:58, Bin Liu wrote:
On Wed, Mar 15, 2017 at 09:08:01AM -0500, Moreno Bartalucci wrote:
With usb-musb port in host mode, when the device
is disconnected, either logically (because of a mode switch) or
physically (by pulling the cable), the USB port should keep
suppling VBUS, with no interruption, to prevent power loss on
USB powered devices.
The usb device has been disconnected, why it still cares about VBUS
power?
Morphing devices (3G dongles, wifi dongles, some printers) boots up in
install mode, usually only as a virtual cd-rom containing Windows
drivers and software.
They get switched into functional mode by usb_modeswitch sending them
a ctrl msg which makes the device disappear from the USB bus for a very
short time after which it re-appears with a different interface
composition and mostly also a different USB Id.
Cutting the VBUS supply while these devices are in progress of switching
will inhibit switching, the device will reboot when VBUS is again
asserted and will come up in initial mode as if no switch ctrl msg had
ever been sent to it.
The problem has been seen both on host only as well as dual-role port
configs. Dual-role may be a bit more complicated to solve because of
the role switching VBUS detection circuit but I can not see any reason
why a host only configured port should cut the VBUS supply, it could be
always on right?
/Lars
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
