Hi all,
Sorry for bothering you but I would like to know whether there are
updates on this or not.
This problem is affecting many people and has been identified, it would
be a pity not to have a fix upstreamed.
Let me know if I can help somehow.
Thank you,
Marco
Il 02/07/2016 12:05, Marco Chiappero ha scritto:
Hi Alan, hi Mathias,
Is there any progress about this problem?
Thank you,
Marco
Il 06/06/2016 19:31, Alan Stern ha scritto:
On Sat, 4 Jun 2016, Marco Chiappero wrote:
On 31/05/2016 16:34, Alan Stern wrote:
On Tue, 31 May 2016, Mathias Nyman wrote:
xhci specs say that port will move from Disconnected (PLS =
RX_DETECT) to
Polling if "SuperSpeed far-end receiver terminations are detected"
From power-off state (PP=0) the connect status changes are only
reported
if OCA is set so it seems that is not an option.
I'm looking at the capture log and if I understand it correcty, in
frame
49 SET FEATURE, PLS = ss.disabled (xhci will write PORT_PED bit)
59 SET FEATURE, PLS = RxDetect (xhci will set pls=RxDetect)
.. get_port_status, nothing set, no changes reported (several of
these)
73 SET FEATURE -> Port remote wake mask
.. get_port status reports Connected, enabled and port status
change event
Could it be that setting the port remote wake mask somehow
triggers the
connect status change event? It's the first time we write to
PORTSC for
this port after setting link state to rx.detect
It's possible, but I doubt it. More likely it just takes a few
hundred
ms for the RxDetect link training to realize there is a connection.
Marco, you can check whether this is true by doing (as root):
echo on >/sys/bus/usb/devices/usb4/power/control
before starting your test.
Alan Stern
Hi,
Sorry for my late reply but I've been very busy this week.
You can find the new captures in the same directory. Or just use the
following direct links:
https://drive.google.com/open?id=0B2tgr9hETOtgTEU1Qmc2eWNIYlE
https://drive.google.com/open?id=0B2tgr9hETOtgZUV2TkZRRGJjMWs
I could not notice any difference though. Anyway I'm happy to test
patches if you want to try changes.
The new capture proves my earlier point. It shows the same sequence of
link-state changes as before (DISABLED -> RX_DETECT -> CONNECTED), but
the port's remote wakeup mask was not set.
As far as I can tell, USB-3 does not have any link state that will
avoid negotiating a connection with a plugged-in cable but will signal
the host when the cable is unplugged. Perhaps the best we can do is
put the link into U3 with remote wakeup disabled on the device.
Mathias, what do you think?
Alan Stern
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
