Hi,
On 23/09/16 21:47, Rob Herring wrote:
On Wed, Sep 21, 2016 at 11:07:07AM +0200, Fabien Lahoudere wrote:
This binding allow to disable the internal 60Mhz clock for USB host2 or
host3.
Signed-off-by: Fabien Lahoudere <fabien.lahoudere@xxxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 +
drivers/usb/chipidea/ci_hdrc_imx.c | 2 ++
drivers/usb/chipidea/ci_hdrc_imx.h | 1 +
drivers/usb/chipidea/usbmisc_imx.c | 13 +++++++++++++
4 files changed, 17 insertions(+)
diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
index 0e03344..f83da66 100644
--- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
+++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt
@@ -84,6 +84,7 @@ i.mx specific properties
- over-current-active-high: over current signal polarity is high active,
typically over current signal polarity is low active.
- external-vbus-divider: enables off-chip resistor divider for Vbus
+- disable-int60ck: disable internal 60MHz clock for usb host2 or host3 on imx53
Doesn't this depend on something else like the type of phy connected? If
not, when can you do this or not?
We can disable it in OTG mode and with ULPI phy and Sascha Hauer think
we can do it without dt binding for example based on PHY mode. So I will
remove the binding and just disable clock if ULPI is selected.
Rob
Fabien
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
