2016-08-16 16:29 GMT+09:00 Felipe Balbi <balbi@xxxxxxxxxx>: > > Hi, > > Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> writes: >> The whole Kconfig entries of the USB subsystem are surrounded with >> "if USB_SUPPORT" ... "endif", so CONFIG_USB_SUPPORT=y is surely met >> when these two Kconfig options are visible. >> >> Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> >> --- >> >> drivers/usb/core/Kconfig | 1 - >> drivers/usb/dwc3/Kconfig | 2 +- >> 2 files changed, 1 insertion(+), 2 deletions(-) >> >> diff --git a/drivers/usb/core/Kconfig b/drivers/usb/core/Kconfig >> index dd28010..253aac7 100644 >> --- a/drivers/usb/core/Kconfig >> +++ b/drivers/usb/core/Kconfig >> @@ -85,7 +85,6 @@ config USB_OTG_FSM >> >> config USB_ULPI_BUS >> tristate "USB ULPI PHY interface support" >> - depends on USB_SUPPORT >> help >> UTMI+ Low Pin Interface (ULPI) is specification for a commonly used >> USB 2.0 PHY interface. The ULPI specification defines a standard set >> diff --git a/drivers/usb/dwc3/Kconfig b/drivers/usb/dwc3/Kconfig >> index 11864e4..3c6213c 100644 >> --- a/drivers/usb/dwc3/Kconfig >> +++ b/drivers/usb/dwc3/Kconfig >> @@ -1,7 +1,7 @@ >> config USB_DWC3 >> tristate "DesignWare USB3 DRD Core Support" >> depends on (USB || USB_GADGET) && HAS_DMA >> - select USB_XHCI_PLATFORM if USB_SUPPORT && USB_XHCI_HCD >> + select USB_XHCI_PLATFORM if USB_XHCI_HCD >> help >> Say Y or M here if your system has a Dual Role SuperSpeed >> USB controller based on the DesignWare USB3 IP Core. > > let's split this patch in two so different maintainers can pick the > relevant pieces. Thanks Greg picked up this patch already. I see it in linux-next now. -- Best Regards Masahiro Yamada -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
