The whole Kconfig entries of the USB subsystem are surrounded with "if USB_SUPPORT" ... "endif", so CONFIG_USB_SUPPORT=y is surely met when these two Kconfig options are visible. Signed-off-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> --- drivers/usb/core/Kconfig | 1 - drivers/usb/dwc3/Kconfig | 2 +- 2 files changed, 1 insertion(+), 2 deletions(-) diff --git a/drivers/usb/core/Kconfig b/drivers/usb/core/Kconfig index dd28010..253aac7 100644 --- a/drivers/usb/core/Kconfig +++ b/drivers/usb/core/Kconfig @@ -85,7 +85,6 @@ config USB_OTG_FSM config USB_ULPI_BUS tristate "USB ULPI PHY interface support" - depends on USB_SUPPORT help UTMI+ Low Pin Interface (ULPI) is specification for a commonly used USB 2.0 PHY interface. The ULPI specification defines a standard set diff --git a/drivers/usb/dwc3/Kconfig b/drivers/usb/dwc3/Kconfig index 11864e4..3c6213c 100644 --- a/drivers/usb/dwc3/Kconfig +++ b/drivers/usb/dwc3/Kconfig @@ -1,7 +1,7 @@ config USB_DWC3 tristate "DesignWare USB3 DRD Core Support" depends on (USB || USB_GADGET) && HAS_DMA - select USB_XHCI_PLATFORM if USB_SUPPORT && USB_XHCI_HCD + select USB_XHCI_PLATFORM if USB_XHCI_HCD help Say Y or M here if your system has a Dual Role SuperSpeed USB controller based on the DesignWare USB3 IP Core. -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
