From: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx>
Two workarounds introduced by commit b8cb91e058cd ("xhci: Workaround
for PME stuck issues in Intel xhci") and commit abce329c27b3 ("xhci:
Workaround to get D3 working in Intel xHCI") share a single quirk bit
XHCI_PME_STUCK_QUIRK. These two workarounds actually are different and
might happen on different hardwares. Need to separate them by adding a
quirk bit for the later.
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx>
Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx>
---
drivers/usb/host/xhci-pci.c | 79 ++++++++++++++++++++++++++-------------------
drivers/usb/host/xhci.h | 1 +
2 files changed, 46 insertions(+), 34 deletions(-)
diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index 67471fb..86377a0 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -156,6 +156,10 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI)) {
xhci->quirks |= XHCI_PME_STUCK_QUIRK;
}
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
+ pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI) {
+ xhci->quirks |= XHCI_SSIC_PORT_UNUSED;
+ }
if (pdev->vendor == PCI_VENDOR_ID_ETRON &&
pdev->device == PCI_DEVICE_ID_EJ168) {
xhci->quirks |= XHCI_RESET_ON_RESUME;
@@ -314,46 +318,47 @@ static void xhci_pci_remove(struct pci_dev *dev)
* SSIC PORT need to be marked as "unused" before putting xHCI
* into D3. After D3 exit, the SSIC port need to be marked as "used".
* Without this change, xHCI might not enter D3 state.
- * Make sure PME works on some Intel xHCI controllers by writing 1 to clear
- * the Internal PME flag bit in vendor specific PMCTRL register at offset 0x80a4
*/
-static void xhci_pme_quirk(struct usb_hcd *hcd, bool suspend)
+static void xhci_ssic_port_unused_quirk(struct usb_hcd *hcd, bool suspend)
{
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
- struct pci_dev *pdev = to_pci_dev(hcd->self.controller);
u32 val;
void __iomem *reg;
int i;
- if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
- pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI) {
-
- for (i = 0; i < SSIC_PORT_NUM; i++) {
- reg = (void __iomem *) xhci->cap_regs +
- SSIC_PORT_CFG2 +
- i * SSIC_PORT_CFG2_OFFSET;
-
- /*
- * Notify SSIC that SSIC profile programming
- * is not done.
- */
- val = readl(reg) & ~PROG_DONE;
- writel(val, reg);
-
- /* Mark SSIC port as unused(suspend) or used(resume) */
- val = readl(reg);
- if (suspend)
- val |= SSIC_PORT_UNUSED;
- else
- val &= ~SSIC_PORT_UNUSED;
- writel(val, reg);
-
- /* Notify SSIC that SSIC profile programming is done */
- val = readl(reg) | PROG_DONE;
- writel(val, reg);
- readl(reg);
- }
+ for (i = 0; i < SSIC_PORT_NUM; i++) {
+ reg = (void __iomem *) xhci->cap_regs +
+ SSIC_PORT_CFG2 +
+ i * SSIC_PORT_CFG2_OFFSET;
+
+ /* Notify SSIC that SSIC profile programming is not done. */
+ val = readl(reg) & ~PROG_DONE;
+ writel(val, reg);
+
+ /* Mark SSIC port as unused(suspend) or used(resume) */
+ val = readl(reg);
+ if (suspend)
+ val |= SSIC_PORT_UNUSED;
+ else
+ val &= ~SSIC_PORT_UNUSED;
+ writel(val, reg);
+
+ /* Notify SSIC that SSIC profile programming is done */
+ val = readl(reg) | PROG_DONE;
+ writel(val, reg);
+ readl(reg);
}
+}
+
+/*
+ * Make sure PME works on some Intel xHCI controllers by writing 1 to clear
+ * the Internal PME flag bit in vendor specific PMCTRL register at offset 0x80a4
+ */
+static void xhci_pme_quirk(struct usb_hcd *hcd)
+{
+ struct xhci_hcd *xhci = hcd_to_xhci(hcd);
+ void __iomem *reg;
+ u32 val;
reg = (void __iomem *) xhci->cap_regs + 0x80a4;
val = readl(reg);
@@ -374,7 +379,10 @@ static int xhci_pci_suspend(struct usb_hcd *hcd, bool do_wakeup)
pdev->no_d3cold = true;
if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
- xhci_pme_quirk(hcd, true);
+ xhci_pme_quirk(hcd);
+
+ if (xhci->quirks & XHCI_SSIC_PORT_UNUSED)
+ xhci_ssic_port_unused_quirk(hcd, true);
return xhci_suspend(xhci, do_wakeup);
}
@@ -406,8 +414,11 @@ static int xhci_pci_resume(struct usb_hcd *hcd, bool hibernated)
if (pdev->vendor == PCI_VENDOR_ID_INTEL)
usb_enable_intel_xhci_ports(pdev);
+ if (xhci->quirks & XHCI_SSIC_PORT_UNUSED)
+ xhci_ssic_port_unused_quirk(hcd, false);
+
if (xhci->quirks & XHCI_PME_STUCK_QUIRK)
- xhci_pme_quirk(hcd, false);
+ xhci_pme_quirk(hcd);
retval = xhci_resume(xhci, hibernated);
return retval;
diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
index 9be7348..cc65138 100644
--- a/drivers/usb/host/xhci.h
+++ b/drivers/usb/host/xhci.h
@@ -1631,6 +1631,7 @@ struct xhci_hcd {
#define XHCI_BROKEN_STREAMS (1 << 19)
#define XHCI_PME_STUCK_QUIRK (1 << 20)
#define XHCI_MTK_HOST (1 << 21)
+#define XHCI_SSIC_PORT_UNUSED (1 << 22)
unsigned int num_active_eps;
unsigned int limit_active_eps;
/* There are two roothubs to keep track of bus suspend info for */
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
