Hi, This series enables the 2 USB ports on the DRA7-evm. NOTE: USB1 port is hard coded to work in peripheral mode and USB2 port in host mode. This is due to missing ID pin interrupt in pre ver.E boards. USB1 port doesn't in peripheral mode out of the box due to missing VBUS detection and mailbox write. To test this I had to do a manual write to enable VBUSVALID in the USB_UTMI_OTG_STATUS register. omapconf set bit 0x48880084 1 USB2 port works well in host mode. Patches are based on 3.15-rc3. cheers, -roger Roger Quadros (7): ARM: dts: dra7-clock: Add "l3init_960m_gfclk" clock gate ARM: DRA7: hwmod: Add SYSCONFIG for usb_otg_ss phy: omap-usb2: Use generic clock names "wkupclk" and "refclk" ARM: dts: omap4+: Add clocks to USB2 PHY node phy: omap-usb2: Add clock names to Documentation binding ARM: dts: dra7: Add USB related nodes dts: dra7-evm: add USB support Documentation/devicetree/bindings/phy/ti-phy.txt | 7 ++ arch/arm/boot/dts/dra7-evm.dts | 24 ++++ arch/arm/boot/dts/dra7.dtsi | 149 +++++++++++++++++++++++ arch/arm/boot/dts/dra7xx-clocks.dtsi | 12 +- arch/arm/boot/dts/omap4.dtsi | 2 + arch/arm/boot/dts/omap5.dtsi | 2 + arch/arm/mach-omap2/omap_hwmod_7xx_data.c | 22 ++-- drivers/phy/phy-omap-usb2.c | 8 +- 8 files changed, 210 insertions(+), 16 deletions(-) -- 1.8.3.2 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
