On Fri, 2014-02-07 at 14:42 +0800, liujunliang_ljl@xxxxxxx wrote: > + netdev_dbg(dev->net, "Write IPG,IPG1,IPG2 failed: %d", ret); [] > + netdev_dbg(dev->net, "RX_CTL is 0x%04x after all initializations", [] > + netdev_dbg(dev->net, "Medium Status : 0x%04x after all initializations", [] > + netdev_dbg(dev->net, "Select PHY #1 failed: %d", ret); [] > + netdev_dbg(dev->net, "RX_CTL is 0x%04x after software reset", rx_ctl); [] > + netdev_dbg(dev->net, "RX_CTL is 0x%04x setting to 0x0000", rx_ctl); [] > + memcpy(data->mac_addr, dev->net->dev_addr, ETH_ALEN); ether_addr_copy > + netdev_err(dev->net, "Failed to power down PHY : %d", ret); [] > + netdev_err(dev->net, "Failed to reset PHY: %d", ret); [] > + netdev_err(dev->net, "Failed to power up PHY: %d", ret); [] > + netdev_err(dev->net, "Failed to reset PHY: %d", ret); [] > + netdev_err(dev->net, "set LINK LED failed : %d", ret); [] > + netdev_dbg(dev->net, "Failed to read MAC address: %d", ret); [] > + netdev_dbg(dev->net, "Select PHY #1 failed: %d", ret); [] > + netdev_dbg(dev->net, "RX_CTL is 0x%04x after software reset", rx_ctl); [] > + netdev_dbg(dev->net, "RX_CTL is 0x%04x setting to 0x0000", rx_ctl); [] > + netdev_dbg(dev->net, "PHYID=0x%08x", phyid); Please make sure all of the netdev_<level> uses have a '\n' line termination. -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
