UART clock is divided using divisor values from DLM/DLL registers when enable-bit is unset in clk register and clk's divider configuration isn't taken onto account in this case. This doesn't cause any problems, but let's add a check for the divider's enable-bit state, for consistency. Acked-by: Peter De Schrijver <pdeschrijver@xxxxxxxxxx> Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx> --- drivers/clk/tegra/clk-divider.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) diff --git a/drivers/clk/tegra/clk-divider.c b/drivers/clk/tegra/clk-divider.c index ca0de5f11f84..38daf483ddf1 100644 --- a/drivers/clk/tegra/clk-divider.c +++ b/drivers/clk/tegra/clk-divider.c @@ -40,8 +40,13 @@ static unsigned long clk_frac_div_recalc_rate(struct clk_hw *hw, int div, mul; u64 rate = parent_rate; - reg = readl_relaxed(divider->reg) >> divider->shift; - div = reg & div_mask(divider); + reg = readl_relaxed(divider->reg); + + if ((divider->flags & TEGRA_DIVIDER_UART) && + !(reg & PERIPH_CLK_UART_DIV_ENB)) + return rate; + + div = (reg >> divider->shift) & div_mask(divider); mul = get_mul(divider); div += mul; -- 2.24.0
