From: Stephen Warren <swarren@xxxxxxxxxx> The reshift hardware module implements the RAM re-repair process. This module uses PLLP as an input clock during LP1 resume. The input divider for this clock is typically set for PLLP's normal rate. During LP1 resume, PLLP is bypassed and so runs at the crystal rate, which is much slower. Consequently, decrease the divider so that the reshift module runs at a reasonable rate during LP1 resume. NVIDIA's downstream kernel code only does this if not compiled for Tegra30, so the added code is made conditional upon the chip ID. Signed-off-by: Stephen Warren <swarren@xxxxxxxxxx> --- arch/arm/mach-tegra/sleep-tegra30.S | 11 +++++++++++ 1 file changed, 11 insertions(+) diff --git a/arch/arm/mach-tegra/sleep-tegra30.S b/arch/arm/mach-tegra/sleep-tegra30.S index 6922dd8d3e2d..6191f9456288 100644 --- a/arch/arm/mach-tegra/sleep-tegra30.S +++ b/arch/arm/mach-tegra/sleep-tegra30.S @@ -59,6 +59,9 @@ #define CLK_RESET_PLLX_MISC3_IDDQ 3 #define CLK_RESET_PLLM_MISC_IDDQ 5 #define CLK_RESET_PLLC_MISC_IDDQ 26 +#define CLK_RESET_PLLP_RESHIFT 0x528 +#define CLK_RESET_PLLP_RESHIFT_DEFAULT 0x3b +#define CLK_RESET_PLLP_RESHIFT_ENABLE 0x3 #define CLK_RESET_CLK_SOURCE_MSELECT 0x3b4 @@ -373,9 +376,13 @@ _pll_m_c_x_done: tegra_get_soc_id TEGRA_APB_MISC_BASE, r1 cmp r1, #TEGRA30 beq 1f + ldr r1, [r0, #CLK_RESET_PLLP_BASE] bic r1, r1, #(1<<31) @ disable PllP bypass str r1, [r0, #CLK_RESET_PLLP_BASE] + + mov r1, #CLK_RESET_PLLP_RESHIFT_DEFAULT + str r1, [r0, #CLK_RESET_PLLP_RESHIFT] 1: mov32 r7, TEGRA_TMRUS_BASE @@ -644,6 +651,10 @@ tegra30_switch_cpu_to_clk32k: orrne r0, r0, #(1 << 31) @ enable PllP bypass on fast cluster bic r0, r0, #(1 << 30) str r0, [r5, #CLK_RESET_PLLP_BASE] + beq 1f + mov r0, #CLK_RESET_PLLP_RESHIFT_ENABLE + str r0, [r5, #CLK_RESET_PLLP_RESHIFT] +1: ldr r0, [r5, #CLK_RESET_PLLA_BASE] bic r0, r0, #(1 << 30) str r0, [r5, #CLK_RESET_PLLA_BASE] -- 2.23.0
