On Thu, Apr 11, 2019 at 10:33:27PM +0530, Manikanta Maddireddy wrote:
> PCIe host power up sequence involves programming AFI(AXI to FPCI bridge)
> registers first and then PCIe registers. Otherwise AFI register settings
> may not latch to PCIe IP.
>
> PCIe root port starts LTSSM as soon as PCIe xrst is deasserted.
> So deassert PCIe xrst after programming PCIe registers.
>
> Modify PCIe power up sequence as follows,
> - Power ungate PCIe partition
> - Enable AFI clock
> - Deassert AFI reset
> - Program AFI registers
> - Enable PCIe clock
> - Deassert PCIe reset
> - Program PCIe registers
> - Deassert PCIe xrst to start LTSSM
>
> Signed-off-by: Manikanta Maddireddy <mmaddireddy@xxxxxxxxxx>
> ---
> drivers/pci/controller/pci-tegra.c | 73 ++++++++++++++++++------------
> 1 file changed, 43 insertions(+), 30 deletions(-)
>
> diff --git a/drivers/pci/controller/pci-tegra.c b/drivers/pci/controller/pci-tegra.c
> index f4f53d092e00..0bf270bcea34 100644
> --- a/drivers/pci/controller/pci-tegra.c
> +++ b/drivers/pci/controller/pci-tegra.c
> @@ -966,9 +966,6 @@ static int tegra_pcie_enable_controller(struct tegra_pcie *pcie)
> }
> }
>
> - /* take the PCIe interface module out of reset */
> - reset_control_deassert(pcie->pcie_xrst);
> -
> /* finally enable PCIe */
> value = afi_readl(pcie, AFI_CONFIGURATION);
> value |= AFI_CONFIGURATION_EN_FPCI;
> @@ -997,8 +994,6 @@ static void tegra_pcie_disable_controller(struct tegra_pcie *pcie)
> {
> int err;
>
> - reset_control_assert(pcie->pcie_xrst);
> -
> if (pcie->soc->program_uphy) {
> err = tegra_pcie_phy_power_off(pcie);
> if (err < 0)
> @@ -1014,13 +1009,11 @@ static void tegra_pcie_power_off(struct tegra_pcie *pcie)
> int err;
>
> reset_control_assert(pcie->afi_rst);
> - reset_control_assert(pcie->pex_rst);
>
> clk_disable_unprepare(pcie->pll_e);
> if (soc->has_cml_clk)
> clk_disable_unprepare(pcie->cml_clk);
> clk_disable_unprepare(pcie->afi_clk);
> - clk_disable_unprepare(pcie->pex_clk);
>
> if (!dev->pm_domain)
> tegra_powergate_power_off(TEGRA_POWERGATE_PCIE);
> @@ -1036,58 +1029,59 @@ static int tegra_pcie_power_on(struct tegra_pcie *pcie)
> const struct tegra_pcie_soc *soc = pcie->soc;
> int err;
>
> - reset_control_assert(pcie->pcie_xrst);
> - reset_control_assert(pcie->afi_rst);
> - reset_control_assert(pcie->pex_rst);
> -
> - if (!dev->pm_domain)
> - tegra_powergate_power_off(TEGRA_POWERGATE_PCIE);
> -
This code was in place to ensure that PCIe was in a known good state
before following the power up sequence below. You mentioned elsewhere
that there's a regression on Cardhu after applying this series, so
perhaps Cardhu relies on the above hunk?
> /* enable regulators */
> err = regulator_bulk_enable(pcie->num_supplies, pcie->supplies);
> if (err < 0)
> dev_err(dev, "failed to enable regulators: %d\n", err);
>
> - if (dev->pm_domain) {
> - err = clk_prepare_enable(pcie->pex_clk);
> + if (!dev->pm_domain) {
> + err = tegra_powergate_power_on(TEGRA_POWERGATE_PCIE);
> if (err) {
> - dev_err(dev, "failed to enable PEX clock: %d\n", err);
> - return err;
> + dev_err(dev, "power ungate failed: %d\n", err);
> + goto regulator_disable;
> }
> - reset_control_deassert(pcie->pex_rst);
> - } else {
> - err = tegra_powergate_sequence_power_up(TEGRA_POWERGATE_PCIE,
> - pcie->pex_clk,
> - pcie->pex_rst);
> + err = tegra_powergate_remove_clamping(TEGRA_POWERGATE_PCIE);
> if (err) {
> - dev_err(dev, "powerup sequence failed: %d\n", err);
> - return err;
> + dev_err(dev, "remove clamp failed: %d\n", err);
> + goto powergate;
> }
> }
>
> - reset_control_deassert(pcie->afi_rst);
> -
> err = clk_prepare_enable(pcie->afi_clk);
> if (err < 0) {
> dev_err(dev, "failed to enable AFI clock: %d\n", err);
> - return err;
> + goto powergate;
> }
>
> if (soc->has_cml_clk) {
> err = clk_prepare_enable(pcie->cml_clk);
> if (err < 0) {
> dev_err(dev, "failed to enable CML clock: %d\n", err);
> - return err;
> + goto afi_clk_disable;
> }
> }
>
> err = clk_prepare_enable(pcie->pll_e);
> if (err < 0) {
> dev_err(dev, "failed to enable PLLE clock: %d\n", err);
> - return err;
> + goto cml_clk_disable;
> }
>
> + reset_control_deassert(pcie->afi_rst);
> +
> return 0;
> +
> +cml_clk_disable:
> + if (soc->has_cml_clk)
> + clk_disable_unprepare(pcie->cml_clk);
> +afi_clk_disable:
> + clk_disable_unprepare(pcie->afi_clk);
> +powergate:
> + if (!dev->pm_domain)
> + tegra_powergate_power_off(TEGRA_POWERGATE_PCIE);
> +regulator_disable:
> + regulator_bulk_disable(pcie->num_supplies, pcie->supplies);
> + return err;
> }
>
> static int tegra_pcie_clocks_get(struct tegra_pcie *pcie)
> @@ -2108,7 +2102,12 @@ static void tegra_pcie_enable_ports(struct tegra_pcie *pcie)
> port->index, port->lanes);
>
> tegra_pcie_port_enable(port);
> + }
> +
> + /* Start LTSSM from Tegra side */
> + reset_control_deassert(pcie->pcie_xrst);
>
> + list_for_each_entry_safe(port, tmp, &pcie->ports, list) {
> if (tegra_pcie_port_check_link(port))
> continue;
>
> @@ -2123,6 +2122,8 @@ static void tegra_pcie_disable_ports(struct tegra_pcie *pcie)
> {
> struct tegra_pcie_port *port, *tmp;
>
> + reset_control_assert(pcie->pcie_xrst);
> +
> list_for_each_entry_safe(port, tmp, &pcie->ports, list)
> tegra_pcie_port_disable(port);
> }
> @@ -2472,6 +2473,9 @@ static int __maybe_unused tegra_pcie_pm_suspend(struct device *dev)
>
> tegra_pcie_disable_ports(pcie);
>
> + reset_control_assert(pcie->pex_rst);
> + clk_disable_unprepare(pcie->pex_clk);
> +
> if (IS_ENABLED(CONFIG_PCI_MSI))
> tegra_pcie_disable_msi(pcie);
>
> @@ -2501,10 +2505,19 @@ static int __maybe_unused tegra_pcie_pm_resume(struct device *dev)
> if (IS_ENABLED(CONFIG_PCI_MSI))
> tegra_pcie_enable_msi(pcie);
>
> + err = clk_prepare_enable(pcie->pex_clk);
> + if (err) {
> + dev_err(dev, "failed to enable PEX clock: %d\n", err);
> + goto disable_controller;
> + }
> + reset_control_deassert(pcie->pex_rst);
> +
> tegra_pcie_enable_ports(pcie);
>
> return 0;
>
> +disable_controller:
> + tegra_pcie_disable_controller(pcie);
> poweroff:
> tegra_pcie_power_off(pcie);
>
There's quite a bit going on in this patch in general and I find it hard
to review because not all the changes seem related to what you described
in the commit message.
Can you perhaps try to split out the error cleanup changes into a
separate patch where it makes sense? It seems to me like at least for
tegra_pcie_power_on() we're currently missing all of the cleanup code.
You could make that a preparatory patch that goes before this particular
patch, which will hopefully make this patch easier to review.
Thierry
Attachment:
signature.asc
Description: PGP signature
