Re: [RFC PATCH 1/2] dt-bindings: mtd: Add bindings for describing concatinated MTD devices

[Krzysztof Kozlowski <krzk@xxxxxxxxxx>]

On 26/10/2024 09:53, Amit Kumar Mahapatra wrote:
> This approach was suggested by Rob [1] during a discussion on Miquel's
> initial approach [2] to extend the MTD-CONCAT driver to support stacked
> memories.
> Define each flash node separately with its respective partitions, and add
> a 'concat-parts' binding to link the partitions of the two flash nodes that
> need to be concatenated.

I understand this was not sent to proper addresses for review because it
is a RFC. It's fine then.

If this was not the intention and this should be reviewed (and tested,
although I assume you tested these patches first), then please read the
standard form bellow:

<form letter>
Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC. It might happen, that command when run on an older
kernel, gives you outdated entries. Therefore please be sure you base
your patches on recent Linux kernel.

Tools like b4 or scripts/get_maintainer.pl provide you proper list of
people, so fix your workflow. Tools might also fail if you work on some
ancient tree (don't, instead use mainline) or work on fork of kernel
(don't, instead use mainline). Just use b4 and everything should be
fine, although remember about `b4 prep --auto-to-cc` if you added new
patches to the patchset.

You missed at least devicetree list (maybe more), so this won't be
tested by automated tooling. Performing review on untested code might be
a waste of time.

Please kindly resend and include all necessary To/Cc entries.
</form letter>

Best regards,
Krzysztof