Avoid of_device_get_match_data() call on each IRQ and each read operation. Store pointer in `struct cqspi_st` device instance. End-to-end performance measurements improve with this patch. On a given octal flash, reading 235M over UBIFS is ~3.4% faster. During that read, the average cqspi_exec_mem_op() call goes from 85.4µs to 80.7µs according to ftrace. The worst case goes from 622.4µs to 615.2µs. Signed-off-by: Théo Lebrun <theo.lebrun@xxxxxxxxxxx> --- drivers/spi/spi-cadence-quadspi.c | 15 ++++++--------- 1 file changed, 6 insertions(+), 9 deletions(-) diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c index 266a5d5dcfaf..02a80745fa6d 100644 --- a/drivers/spi/spi-cadence-quadspi.c +++ b/drivers/spi/spi-cadence-quadspi.c @@ -102,6 +102,8 @@ struct cqspi_st { bool apb_ahb_hazard; bool is_jh7110; /* Flag for StarFive JH7110 SoC */ + + const struct cqspi_driver_platdata *ddata; }; struct cqspi_driver_platdata { @@ -334,11 +336,8 @@ static u32 cqspi_get_versal_dma_status(struct cqspi_st *cqspi) static irqreturn_t cqspi_irq_handler(int this_irq, void *dev) { struct cqspi_st *cqspi = dev; + const struct cqspi_driver_platdata *ddata = cqspi->ddata; unsigned int irq_status; - struct device *device = &cqspi->pdev->dev; - const struct cqspi_driver_platdata *ddata; - - ddata = of_device_get_match_data(device); /* Read interrupt status */ irq_status = readl(cqspi->iobase + CQSPI_REG_IRQSTATUS); @@ -1358,16 +1357,13 @@ static ssize_t cqspi_read(struct cqspi_flash_pdata *f_pdata, const struct spi_mem_op *op) { struct cqspi_st *cqspi = f_pdata->cqspi; - struct device *dev = &cqspi->pdev->dev; - const struct cqspi_driver_platdata *ddata; + const struct cqspi_driver_platdata *ddata = cqspi->ddata; loff_t from = op->addr.val; size_t len = op->data.nbytes; u_char *buf = op->data.buf.in; u64 dma_align = (u64)(uintptr_t)buf; int ret; - ddata = of_device_get_match_data(dev); - ret = cqspi_read_setup(f_pdata, op); if (ret) return ret; @@ -1823,7 +1819,8 @@ static int cqspi_probe(struct platform_device *pdev) /* write completion is supported by default */ cqspi->wr_completion = true; - ddata = of_device_get_match_data(dev); + ddata = of_device_get_match_data(dev); + cqspi->ddata = ddata; if (ddata) { if (ddata->quirks & CQSPI_NEEDS_WR_DELAY) cqspi->wr_delay = 50 * DIV_ROUND_UP(NSEC_PER_SEC, -- 2.44.0