On 30/10/20 01:31PM, Ramuthevar,Vadivel MuruganX wrote: > From: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx> > > On Intel Lightning Mountain(LGM) SoCs QSPI controller do not use > Direct Access Controller(DAC). > > This patch adds a quirk to disable the Direct Access Controller > for data transfer instead it uses indirect data transfer. > > Signed-off-by: Ramuthevar Vadivel Murugan <vadivel.muruganx.ramuthevar@xxxxxxxxxxxxxxx> > --- > drivers/spi/spi-cadence-quadspi.c | 12 ++++++++++++ > 1 file changed, 12 insertions(+) > > diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c > index d7b10c46fa70..6d6f7c440ece 100644 > --- a/drivers/spi/spi-cadence-quadspi.c > +++ b/drivers/spi/spi-cadence-quadspi.c > @@ -1107,6 +1107,13 @@ static void cqspi_controller_init(struct cqspi_st *cqspi) > writel(reg, cqspi->iobase + CQSPI_REG_CONFIG); > > cqspi_controller_enable(cqspi, 1); > + > + /* Disable direct access controller */ > + if (!cqspi->use_direct_mode) { > + reg = readl(cqspi->iobase + CQSPI_REG_CONFIG); > + reg &= ~CQSPI_REG_CONFIG_ENB_DIR_ACC_CTRL; > + writel(reg, cqspi->iobase + CQSPI_REG_CONFIG); > + } You did not address my comment here from last time around [0]. Please replace this hunk with the one below and test it. Also mention in the commit message that the DAC bit resets to 1 so there is no need to explicitly set it. --- 8< --- diff --git a/drivers/spi/spi-cadence-quadspi.c b/drivers/spi/spi-cadence-quadspi.c index d7ad8b198a11..d2c5d448a944 100644 --- a/drivers/spi/spi-cadence-quadspi.c +++ b/drivers/spi/spi-cadence-quadspi.c @@ -2156,10 +2156,12 @@ static void cqspi_controller_init(struct cqspi_st *cqspi) writel(cqspi->fifo_depth * cqspi->fifo_width / 8, cqspi->iobase + CQSPI_REG_INDIRECTWRWATERMARK); - /* Enable Direct Access Controller */ - reg = readl(cqspi->iobase + CQSPI_REG_CONFIG); - reg |= CQSPI_REG_CONFIG_ENB_DIR_ACC_CTRL; - writel(reg, cqspi->iobase + CQSPI_REG_CONFIG); + /* Disable Direct Access Controller */ + if (!cqspi->use_dac_mode) { + reg = readl(cqspi->iobase + CQSPI_REG_CONFIG); + reg &= ~CQSPI_REG_CONFIG_ENB_DIR_ACC_CTRL; + writel(reg, cqspi->iobase + CQSPI_REG_CONFIG); + } cqspi_controller_enable(cqspi, 1); } --- >8 --- Same disclaimer as last time: not tested at all. [0] https://lore.kernel.org/linux-spi/20201022090146.2uj5gfx73dsfumjl@xxxxxx/ PS: Please Cc me in the next revision. I missed 3 revisions in between because I'm not subscribed to this list. Otherwise I would have sent this much sooner :-) > } > > static int cqspi_request_mmap_dma(struct cqspi_st *cqspi) > @@ -1388,6 +1395,10 @@ static const struct cqspi_driver_platdata am654_ospi = { > .quirks = CQSPI_NEEDS_WR_DELAY, > }; > > +static const struct cqspi_driver_platdata intel_lgm_qspi = { > + .quirks = CQSPI_DISABLE_DAC_MODE, > +}; > + > static const struct of_device_id cqspi_dt_ids[] = { > { > .compatible = "cdns,qspi-nor", > @@ -1403,6 +1414,7 @@ static const struct of_device_id cqspi_dt_ids[] = { > }, > { > .compatible = "intel,lgm-qspi", > + .data = &intel_lgm_qspi, > }, > { /* end of table */ } > }; > -- > 2.11.0 > -- Regards, Pratyush Yadav Texas Instruments India