Signed-off-by: kernel test robot <lkp@xxxxxxxxx> --- spi-aspeed.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/spi/spi-aspeed.c b/drivers/spi/spi-aspeed.c index 795f67c9ca6ac3..6b067dee833246 100644 --- a/drivers/spi/spi-aspeed.c +++ b/drivers/spi/spi-aspeed.c @@ -144,7 +144,7 @@ static void aspeed_spi_chip_set_4byte(struct aspeed_spi_controller *ast_ctrl, writel(reg_val, ast_ctrl->regs + OFFSET_CE_ADDR_MODE_CTRL); } -uint32_t aspeed_spi_get_io_mode(uint32_t bus_width) +static uint32_t aspeed_spi_get_io_mode(uint32_t bus_width) { switch (bus_width) { case 1: @@ -295,8 +295,8 @@ aspeed_2600_spi_clk_basic_setting(struct aspeed_spi_controller *ast_ctrl, * content is too monotonous, the frequency recorded in the device * tree will be adopted. */ -int aspeed_2600_spi_timing_calibration(struct aspeed_spi_controller *ast_ctrl, - uint32_t cs) +static int aspeed_2600_spi_timing_calibration(struct aspeed_spi_controller *ast_ctrl, + uint32_t cs) { int ret = 0; struct device *dev = ast_ctrl->dev; @@ -432,7 +432,7 @@ int aspeed_2600_spi_timing_calibration(struct aspeed_spi_controller *ast_ctrl, * of its related flash size. Namely, the total decoded size * from flash 0 to flash N should be multiple of flash (N + 1). */ -void aspeed_2600_adjust_decode_sz(uint32_t decode_sz_arr[], int len) +static void aspeed_2600_adjust_decode_sz(uint32_t decode_sz_arr[], int len) { int cs, j; uint32_t sz;