Re: [PATCH 5/8] spi: spi-s3c64xx: Fix doc comment for struct s3c64xx_spi_driver_data

[Krzysztof Kozlowski <krzk@xxxxxxxxxx>]

On Wed, Aug 19, 2020 at 02:32:05PM +0200, Łukasz Stelmach wrote:
> Signed-off-by: Łukasz Stelmach <l.stelmach@xxxxxxxxxxx>

Hi,

Missing commit msg - fix what exactly?

You need to rebase your patch as most of these were already fixed by Lee
Jones.

However he did not remove the @rx_dmach and tx entries...

Best regards,
Krzysztof

> ---
>  drivers/spi/spi-s3c64xx.c | 10 ++++++----
>  1 file changed, 6 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
> index 6fe896f2be18..505789f91fdf 100644
> --- a/drivers/spi/spi-s3c64xx.c
> +++ b/drivers/spi/spi-s3c64xx.c
> @@ -155,19 +155,21 @@ struct s3c64xx_spi_port_config {
>   * @clk: Pointer to the spi clock.
>   * @src_clk: Pointer to the clock used to generate SPI signals.
>   * @ioclk: Pointer to the i/o clock between master and slave
> + * @pdev: Pointer to the SPI controller platform device
>   * @master: Pointer to the SPI Protocol master.
>   * @cntrlr_info: Platform specific data for the controller this driver manages.
>   * @lock: Controller specific lock.
>   * @state: Set of FLAGS to indicate status.
> - * @rx_dmach: Controller's DMA channel for Rx.
> - * @tx_dmach: Controller's DMA channel for Tx.
> + * @rx_dma: Controller's DMA channel for Rx.
> + * @tx_dma: Controller's DMA channel for Tx.
>   * @sfr_start: BUS address of SPI controller regs.
>   * @regs: Pointer to ioremap'ed controller registers.
> - * @irq: interrupt
>   * @xfer_completion: To indicate completion of xfer task.
>   * @cur_mode: Stores the active configuration of the controller.
>   * @cur_bpw: Stores the active bits per word settings.
>   * @cur_speed: Stores the active xfer clock speed.
> + * @port_conf: Pointer to the SPI port configuration
> + * @port_id: SPI port ID number
>   */