[PATCH 1/2] spi: cadence: Init HW after reading devicetree attributes

[Lars-Peter Clausen <lars@xxxxxxxxxx>]

From: Paul Cercueil <paul.cercueil@xxxxxxxxxx>

This will make it possible to use the settings specified in the devicetree
to configure the hardware.

Signed-off-by: Paul Cercueil <paul.cercueil@xxxxxxxxxx>
Signed-off-by: Lars-Peter Clausen <lars@xxxxxxxxxx>
---
 drivers/spi/spi-cadence.c | 24 +++++++++++-------------
 1 file changed, 11 insertions(+), 13 deletions(-)

diff --git a/drivers/spi/spi-cadence.c b/drivers/spi/spi-cadence.c
index 7b811e3..2404937 100644
--- a/drivers/spi/spi-cadence.c
+++ b/drivers/spi/spi-cadence.c
@@ -516,6 +516,17 @@ static int cdns_spi_probe(struct platform_device *pdev)
 		goto clk_dis_apb;
 	}
 
+	ret = of_property_read_u32(pdev->dev.of_node, "num-cs", &num_cs);
+	if (ret < 0)
+		master->num_chipselect = CDNS_SPI_DEFAULT_NUM_CS;
+	else
+		master->num_chipselect = num_cs;
+
+	ret = of_property_read_u32(pdev->dev.of_node, "is-decoded-cs",
+				   &xspi->is_decoded_cs);
+	if (ret < 0)
+		xspi->is_decoded_cs = 0;
+
 	/* SPI controller initializations */
 	cdns_spi_init_hw(xspi);
 
@@ -534,19 +545,6 @@ static int cdns_spi_probe(struct platform_device *pdev)
 		goto remove_master;
 	}
 
-	ret = of_property_read_u32(pdev->dev.of_node, "num-cs", &num_cs);
-
-	if (ret < 0)
-		master->num_chipselect = CDNS_SPI_DEFAULT_NUM_CS;
-	else
-		master->num_chipselect = num_cs;
-
-	ret = of_property_read_u32(pdev->dev.of_node, "is-decoded-cs",
-				   &xspi->is_decoded_cs);
-
-	if (ret < 0)
-		xspi->is_decoded_cs = 0;
-
 	master->prepare_transfer_hardware = cdns_prepare_transfer_hardware;
 	master->prepare_message = cdns_prepare_message;
 	master->transfer_one = cdns_transfer_one;
-- 
1.8.0

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html