Hello Guys, I have compiled MCP251x.c kernel driver module for Olimex A20-Olinuxino Micro. The device is working fine for one frame at a time at 500ms. If I send two or more frame at the same time, CAN is going to bus-off due to overrun errors. Even if I send one frame at faster rate say, 100ms,results in bus-off. I am communicating with module with ip commands, cansend & candump. Also my SPI module is working only at 250K baud, not any other baud. Any suggestions. Best Regards, Pankaj -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
MCP2515 implementation is slow
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Subject: MCP2515 implementation is slow
- From: "Pankajkumar Misra (RBEI/EEA2)" <Pankaj.Kumar@xxxxxxxxxxxx>
- Date: Tue, 25 Nov 2014 16:19:33 +0000
- Accept-language: en-US, en-SG
- Thread-topic: MCP2515 implementation is slow
- Follow-Ups:
- Re: MCP2515 implementation is slow
- From: David Jander
- Re: MCP2515 implementation is slow
- Prev by Date: Re: [PATCH v8 3/8] OF: DT-Overlay configfs interface (v2)
- Next by Date: Re: [PATCH 2/2 v2] SPI: spi-pxa2xx: SPI support for Intel Quark X1000
- Previous by thread: [PATCH v2 13/14] spi/of: Create new device registration method and accessors
- Next by thread: Re: MCP2515 implementation is slow
- Index(es):
 |