[PATCH v2] spi: add "spi-lsb-first" to devicetree

[Zhao Qiang <B45475@xxxxxxxxxxxxx>]

add optional property devicetree for SPI slave nodes
into devicetree so that LSB mode can be enabled by devicetree.

Signed-off-by: Zhao Qiang <B45475@xxxxxxxxxxxxx>
---
changs for v2:
	- remove duplicate "spi-rx-bus-width" 
 Documentation/devicetree/bindings/spi/spi-bus.txt | 2 ++
 drivers/spi/spi.c                                 | 2 ++
 2 files changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/spi/spi-bus.txt b/Documentation/devicetree/bindings/spi/spi-bus.txt
index e5a4d1b..22d5740 100644
--- a/Documentation/devicetree/bindings/spi/spi-bus.txt
+++ b/Documentation/devicetree/bindings/spi/spi-bus.txt
@@ -55,6 +55,8 @@ contain the following properties.
     		chip select active high
 - spi-3wire       - (optional) Empty property indicating device requires
     		    3-wire mode.
+- spi-lsb-first   - (optional) Empty property indicating device requires
+		LSB first mode.
 - spi-tx-bus-width - (optional) The bus width(number of data wires) that
                       used for MOSI. Defaults to 1 if not present.
 - spi-rx-bus-width - (optional) The bus width(number of data wires) that
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 23756b0..0a20a90 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1050,6 +1050,8 @@ static void of_register_spi_devices(struct spi_master *master)
 			spi->mode |= SPI_CS_HIGH;
 		if (of_find_property(nc, "spi-3wire", NULL))
 			spi->mode |= SPI_3WIRE;
+		if (of_find_property(nc, "spi-lsb-first", NULL))
+			spi->mode |= SPI_LSB_FIRST;
 
 		/* Device DUAL/QUAD mode */
 		if (!of_property_read_u32(nc, "spi-tx-bus-width", &value)) {
-- 
1.8.5


--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html