Hi there,
Do you have a sample of the sounding board?
I also have 2 of them, including installation software.
Must choose synth sources with care however, wanting to hear it before
even considering putting it in as a backup.
On Wed, 1 Nov 2023, Butch Bussen wrote:
As I recall on the sounding board, irq 2 was default, and we sometimes used
seven. I think 5 was for sound card, irq 4 was for come 1 and 3 and irq3 was
for com 2 and com 4 as I recall. On Tue, 31 Oct 2023, K0LNY ?? wrote:
I thought that somewhere in with the DecTalk files, there was a tool that
probes for the Dectalk.
It should not be hard to change the jumpers on the card, I used to do it
all
the time.
Seems like I usually used IRQ 5 or 7 and what is the other, DMA?
I think that was usually 3.
Anyway, it wouldn't hurt to move them, as the worse that can happen is
that
it will be not working like it it is currently.
You just feel the the available jumper pins, and move the jumper over.
Glenn
----- Original Message -----
From: "Butch Bussen" <butchb@xxxxxxxxxxxxxx>
To: "Karen Lewellen" <klewellen@xxxxxxxxxxxxxx>
Cc: "Speakup is a screen review system for Linux."
<speakup@xxxxxxxxxxxxxxxxx>
Sent: Tuesday, October 31, 2023 7:10 PM
Subject: Re: slightly different dectalk question.
I don't know of a tool, but I have a whole folder of dectalk stuff, says
software 4.2 if I remember right. There is one file, for example, that
talks about a conflict with certain cdrom drives.
On Tue, 31 Oct 2023,
Karen Lewellen wrote:
> And likely more on point.
> I did get a copy of the pc1 software, from another list.
> The error suggests address factors, but my associate took one look at
> all
> those switches and was afraid to touch them.
> Given dt.bat can be edited it seems,
> any tool that will locate the dectalk internal card?
> Thanks,
> Karen
>
>
>
>
