Wow. This product sounds amazing. Would you care to share the manufacture of your hardware synthesizer or have a company to recommend? You save this works with a device even if it does not have speakers, so this means it either has a speaker in bedded or you connect headphones, etc. Is it possible to use one of these, a hardware speech synthesizer, to read anything that outputs text; so with this mean that in theory you could even use one of these with an operating system and no software screen reader or even a machine that doesn’t have anything for accessibility, such as a TV or ATM machine? I’m guessing it just grabs the plaintext that is visually output, I would think that would allow you to use a device like that with almost anything that has a USB port and outputs text, am I correct on that assumption? Thank you, -Reece > On Dec 16, 2020, at 4:37 PM, Karen Lewellen <klewellen@xxxxxxxxxxxxxx> wrote: > > out of curiosity, does fenrir work with any dectalk hardware? > Kare > > > >> On Wed, 16 Dec 2020, Janina Sajka wrote: >> >> I agree with this advice. However, getting both environments function >> with speech could prove to be a challenge on your hardware. >> >> Speech Dispatcher doesn't play with Speakup. There are other >> complications that may, or may not prove problematical. >> >> Your best bet might be Fenrir. >> >> My current solution is as follows: >> >> Speakup using espeak with the espeakup connector. Note this is the old >> espeak, not espeak-ng. >> >> Orca with Speech-Dispatcher using RH Voice. >> >> FYI: I'm on a fully updated Arch. >> >> Best, >> >> Janina >> >> Zachary Kline writes: >>> Hi, >>> >>> To be perfectly honest, I recommend using Speakup for good terminal support. Orca is rather sub-par in this regard, and Speakup was designed to fully support command-line output from the start. >>> Best, >>> Zack. >>> >>>> On Dec 14, 2020, at 10:52 AM, Reece O'Bryan <reece.obryan@xxxxxxxxxx> wrote: >>>> >>>> Hello, >>>> >>>> I’m having trouble efficiently accessing outputs from terminal in Orca. I need a fully functioning screen reader, is there an easy way to navigate line by line of output from terminal in espeakup or orca? >>>> >>>> Thank you, >>>> >>>> -Reece >>>> _______________________________________________ >>>> Speakup mailing list >>>> Speakup@xxxxxxxxxxxxxxxxx >>>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup >>> >>> _______________________________________________ >>> Speakup mailing list >>> Speakup@xxxxxxxxxxxxxxxxx >>> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup >> >> -- >> >> Janina Sajka >> https://linkedin.com/in/jsajka >> >> Linux Foundation Fellow >> Executive Chair, Accessibility Workgroup: http://a11y.org >> >> The World Wide Web Consortium (W3C), Web Accessibility Initiative (WAI) >> Co-Chair, Accessible Platform Architectures http://www.w3.org/wai/apa >> >> _______________________________________________ >> Speakup mailing list >> Speakup@xxxxxxxxxxxxxxxxx >> http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup >> > _______________________________________________ > Speakup mailing list > Speakup@xxxxxxxxxxxxxxxxx > http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup _______________________________________________ Speakup mailing list Speakup@xxxxxxxxxxxxxxxxx http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
