Oh, I'm sure it's good information, friend, I'm just not having much
luck. Think tha'ts more on my end. I'm not as good at this as I should be.
Mark Peveto
Registered linux number 600552
Sent from sonar using thunderbird.
On 05/26/2016 02:11 PM, Willem Venter wrote:
Hi.
Pulseaudio takes complete control of the audio device, so when other
devices try to use the soundcard through alsa things break.
A work around I use is playing sound using dmix. This means a bit more
processing and possibly a little latency for programs using pulse, but
on the other hand it's better than broken sound.
Remove package pulseaudio-alsa, which provides compatibility layer
between ALSA applications and PulseAudio. After this your ALSA apps
will use ALSA directly without being hooked by Pulse.
Edit /etc/pulse/default.pa.
Find and uncomment lines which load back-end drivers. Add device
parameters as follows. Then find and comment lines which load
autodetect modules.
load-module module-alsa-sink device=dmix
load-module module-alsa-source device=dsnoop
# load-module module-udev-detect
# load-module module-detect
After rebooting pulseaudio won't grab the sound device, but instead
plays it through dmix.
hth
Willem
On 5/26/16, Mark Peveto <southernprince73@xxxxxxxxx> wrote:
Here's the error I was talking about earlier.
Back story: I'm trying to get console speech. Since i can't right now,
I'm doing this from a terminal, which reads badly. Once I type sudo
espeakup, it'll read the top of the console screen, and the login prompt
asking for a username. After that it gives an error which i'll post. I
know it's a pulseaudio problem. Most suggest I get rid of pulseaudio,
and if that's the only solution there is, I guess i'll have to, but that
creates more problems when it comes to having the system rediscover new
sound drivers. Long explanation short, it jacks things up!
Error follows.
[southernprince@roxie ~]$ sudo espeakup
[sudo] password for southernprince:
[southernprince@roxie ~]$ Assertion 'p' failed at pulse/simple.c:273,
function pa_simple_write(). Aborting.
It should be noted here that the error does not appear until I start to
type. It reads the login prompt, and once i hit the s for
southernprinc, my username, the error appears. If I could figure out
how, I might turn keyecho off, which I wanna do anyway, but I don't know
if that'd help anything.
There ya have it folks.
_______________________________________________
Speakup mailing list
Speakup@xxxxxxxxxxxxxxxxx
http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
_______________________________________________
Speakup mailing list
Speakup@xxxxxxxxxxxxxxxxx
http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
_______________________________________________
Speakup mailing list
Speakup@xxxxxxxxxxxxxxxxx
http://linux-speakup.org/cgi-bin/mailman/listinfo/speakup
