ok. I got my 20 gb set to master. For the bios settings, do I just set it under cd? or where do I need to change it at? Thanks, ----- Original Message ----- From: "Doug Sutherland" <doug@xxxxxxxxxxx> To: "Speakup is a screen review system for Linux." <speakup at braille.uwo.ca> Sent: Thursday, May 17, 2007 7:01 PM Subject: Re: three hds? is this possible? > On most IDE motherboards you have two IDE controllers, > each can support one master and one slave on a single cable. > You may need to set jumpers on the actual drives to get them > set up correctly, one jumpered as master, one jumpered as > slave on each controller. > > The jumper setting info will be labeled on the drives. > You may also need to check the BIOS settings and make > sure that all four drives are enabled, and on older BIOS you > may need to set them to the correct setting for the drive, > while on newer BIOS usually setting them all to AUTO will > auto-detect the drives and configure the BIOS appropriately. > > -- Doug > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup
