You should extract speech-dispatcher, change to its directory, do ./configure&&make&&make install Note the punctuation in the line above. You also need speechd-up which you can also get where you got speech-dispatcher. I think it also requires dotconf. HTH Willem On Wed, 17 May 2006, Satyam wrote: > Dear all, > I installed speakup modified Fc3 and planning to use speakup using > software synth. As per the instructions given in the howto install > speakup guide I downloaded speech dispatcher 0.6 and > festival-freebsoft-utils-0.6 After careful reading the install document > of speech dispatcher I issued the command > Make all > Then I am getting the following error: No rule to make target all.stop > What is the cause for this message and how to rectify it. > Hope to hear from you. > Satyam. > > > > -- > No virus found in this outgoing message. > Checked by AVG Free Edition. > Version: 7.1.385 / Virus Database: 268.6.0/341 - Release Date: 5/16/2006 > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup > -- This message is subject to the CSIR's copyright, terms and conditions and e-mail legal notice. Views expressed herein do not necessarily represent the views of the CSIR. CSIR E-mail Legal Notice http://mail.csir.co.za/CSIR_eMail_Legal_Notice.html CSIR Copyright, Terms and Conditions http://mail.csir.co.za/CSIR_Copyright.html For electronic copies of the CSIR Copyright, Terms and Conditions and the CSIR Legal Notice send a blank message with REQUEST LEGAL in the subject line to HelpDesk at csir.co.za. This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. MailScanner thanks Transtec Computers for their support.
