There have been several postings here recently about DSL modem configuration. In case it's helpful, below is the list of URLs that directly access the various configuration pages on a Westell Wirespeed 327W. Getting to these from the main page at 192.168.1.1 is very speech unfriendly. But, by going directly to these addresses, all of the options can be configured. Initiating new DSL service (at least with Verizon) can be accomplished completely through these addresses and an external web account setup page, all without installing any software on home PCs. Also, the Westell can be placed in bridge mode and connected to a Linksys running OpenWRT. The required PPPoE service runs in the Linksys and everything in the home network can then be configured via command line interface to the Linux OpenWRT firmware in the router. Westell may use these same addresses on other DSL boxes besides the 327W . Jim Kutsch Morristown, NJ Westell Wirespeed 327W configuration pages: http://192.168.1.1/singleStaticIP.htm http://192.168.1.1/ethwancfg.htm http://192.168.1.1/nat.htm http://192.168.1.1/fwMain.htm http://192.168.1.1/802_11_cfg.htm http://192.168.1.1/dns.htm http://192.168.1.1/dhcp.htm?dhcpOpt=1 http://192.168.1.1/privLan.htm?dhcpOpt=1 http://192.168.1.1/pubLan.htm?dhcpOpt=1 http://192.168.1.1/cos.htm http://192.168.1.1/atmlp.htm http://192.168.1.1/autodisc.htm http://192.168.1.1/qos.htm?qosQIndex=0&qosLIndex=0&qosIpFragSizeCur=244 http://192.168.1.1/route.htm http://192.168.1.1/rip.htm?EnableRIPCur=0&ripAuthModeCur=1&ripRcvTypeCur=2&ripXmtTypeCur=3
