-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hate to disappoint you Igor, but my dmesg output says: parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP] and as I've mentioned before, I can cat files to the blazer just fine. Your blazer firmware is a different story though. My firmware revision is October 1, 1999, and I was told on the FS support list that this is the newest firmware when I asked. So, you might want to contact CAT or FS to find out if they can replace your blazer's EPROM. Greg On Fri, Jun 25, 2004 at 10:29:33PM -0400, Igor Gueths wrote: > Hi all. Just recently, I figured out how to get into the bios on this machine, and was able to change the parallel port mode. However, I think I am basically screwed on this whole thing > because it seems the port does not support ECP, and I figured out through a working laptop that that's the propper mode for the Blazer to comprehend the input. In further digging, I also > discovered the following in dmesg: parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP] > > Judging from that output, would I be correct in assuming that this port only supports modes PCSPP, TRISTATE, and EPP? Because if so, I will never be able to print to the blazer using this > motherboard anyway. Unless there is perhaps a newer version of the Blazer's firmware that does support EPP? The current version I am using is the August 20, 1993 revision. Thanks! > -- > Failure is not an option, it comes bundled with your Microsoft product. > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > !DSPAM:40dce72a20401232114000! > > - -- Free domains: http://www.eu.org/ or mail dns-manager at EU.org -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.3 (GNU/Linux) iD8DBQFA3Oz17s9z/XlyUyARAr8VAKDIpm+L81B6P/3NF219NlQ4o0e3QQCeJll1 99zYtSio0vzrqNnMd8taGyc= =8WED -----END PGP SIGNATURE-----
