-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 this isn't the express. it's the original dectalk. uses the decext driver. On Tue, Jun 15, 2004 at 06:47:28PM -0400, Jayson Smith wrote: > The Dectalk Express is set up to receive data sent at 9600 baud, 8 data > bits, 1 stop bit, and no parity. I'd assume that's what Speakup would > probably expect. At any rate, that would be a good starting point. > Jayson. > > ----- Original Message ----- > From: "Alex Snow" <alex_snow at gmx.net> > To: "Speakup list" <speakup at braille.uwo.ca> > Sent: Tuesday, June 15, 2004 4:50 PM > Subject: dectalk question > > > > -----BEGIN PGP SIGNED MESSAGE----- > > Hash: SHA1 > > > > Hi all. I finally got into the setup interface of my dtc01 to see if I > > can get it to run with speakup. What com parameters does speakup expect > > from the dectalk? I'm asuming the parameters for the "host" are what I > > should change. like the default baud is 1200. is this what speakup > > expects? > > > > - -- > > Linux is addictive, I'm hooked! > > -- MaDsen Wikholm's .sig > > -----BEGIN PGP SIGNATURE----- > > Version: GnuPG v1.2.3 (GNU/Linux) > > > > iD8DBQFAz2El9XVrM3ri110RAi61AJ0QOS1trMCRWx4e/yEGNwue+UWH2gCbBMBJ > > xUMTZpoKoAMw27ktuyt5tiU= > > =CC91 > > -----END PGP SIGNATURE----- > > > > _______________________________________________ > > Speakup mailing list > > Speakup at braille.uwo.ca > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup - -- ... faster BogoMIPS calculations (yes, it now boots 2 seconds faster than it used to: we're considering changing the name from "Linux" to "InstaBOOT" -- Linus, in the announcement for 1.3.26 -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.3 (GNU/Linux) iD8DBQFAz6Fk9XVrM3ri110RAtgNAJ9KPH3ntzaPZmeyHo0jfjtHBWTCfQCfdah8 SbnF3U43/gg4HXbSuDs4BMI= =be1v -----END PGP SIGNATURE-----
