Note: this applies to the new CVS version of Speakup.
1. What is the earliest point I can insert an echo command to the
/proc/speakup/synth_name to set up a synth. driver?
2. When attempting to load the speakout driver while currently logged
in, I get the following messages shown in dmesg and the load
obvously fails.
Speakup: loading module "speakup_spkout"
releasing synth acntpc
Probing for Speakout.
Speakout Out: not found
spkout: device probe failed
Now, I understand there is a setserial sequence I should do; can
someone tell me what that sequence is? when I tried
setserial /dev/ttyS0 uart none, I got no complaints but I got the
above messages when I echoed 'spkout' to /proc/speakup/synth_name.
Thanks for any help.
