Hi Gordon
You didn't say you had two controllers. That makes life a bit different.
First off the kernel needs to have support build in for your second
controller. well really your third and fourth controller most likely. I
do believe that slackware has support for the promise controllers built in
to the bare.i boot disk. If not this could be a bit of a problem assuming
that is the kind of controller you have. In either case it is probable
that the drive that is in question is really /dev/hde.
If you need anymore help just call or write. It could get a little tricky
to set this up and boot off of that drive. Unless your thinking of
booting from a floppy the lilo config to boot this setup will prove to be a
learning experience for you.
--
Frank Carmickle
phone: 412 761-9568
email: frankiec at dryrose.com
