Did you try compiling soundcore into the kernel itself? Greg On Fri, Sep 07, 2001 at 02:02:21PM -0400, jwantz at hpcc2.hpcc.noaa.gov wrote: > Hi Greg, > Yes to both questions. depmod -a doesn't report any module dependecies > problems either. One thing though, shouldn't I be running soundcore? > I'm not. Strangely, it wasn't where it should be. So I moved a copy to > where it should be (I had to create the directory) and did a modprobe > and the kernel told me that it couldn't find the module for the kernel > version. This seemed absurd since I knew the file was built the same > time as the kernel. In fact I got it out of the kernel source tree. I > even tried re-running modules_install with no success. > Incidentally, when you are using the new beta stuff alsactl writes intou > a file called asound.state rather than asound.conf. I'm not sure why > they made that change. > > Jim > On Thu, 6 Sep 2001, Gregory Nowak wrote: > > > Did you load all modules for that card, and did you run alsactl? > > Greg > > > > > > On Wed, Sep 05, 2001 at 09:53:14PM -0400, jwantz at hpcc2.hpcc.noaa.gov wrote: > > > Hi All, > > > I have observed some odd behavior. My Speakup (well actually the whole > > > kernel) was locking up. Speakup is working fine, but Alsa doesn't work. > > > I have tried 0.5.11/10 and 0.90beta7 with the same results. However, I > > > noticed that in /proc/asound/sndstat that it was complaining about sound > > > devices not being initialized. This seems to be a common alsa problem, > > > because I find all kinds of references to it on the net. What is > > > lacking is solutions. I'm using an AWE64 Gold and I am compiling in > > > isapnp support when I configure the drivers.Well, one good thing about > > > this problem I'm learning a lot about Alsa! > > > > > > Jim Wantz > > > On Mon, 3 Sep 2001, Brian > > > Borowski wrote: > > > > > > > > > > > > > > > Kirk: > > > > I left out details. I'm running linux-2.4.9-ac5 with your latest speakup, > > > > and also the alsa 0.5.11/10 stuff, with absolutely no trouble. Thanks > > > > again for the work. > > > > > > > > Brian > > > > > > > > > > > > > > > > On Thu, 30 Aug 2001, Kirk Reiser wrote: > > > > > > > > > Hi Folks: I have made quite a few changes to speakup in cvs over the > > > > > past two weeks. > > > > > > > > > > First of all I rewrote the keyboard.c interface for the 2.2.x and > > > > > 2.4.x trees to bring speakup into conformance with the official kernel > > > > > tree. > > > > > > > > > > I also rewrote the way speakup registers the /dev/synth misc device to > > > > > allow the 2.4.x kernels to use devfs. > > > > > > > > > > Finally, I rewrote the speakup interface to drivers/char/Makefile and > > > > > drivers/char/speakup/Makefile to utilize Shanes suggestion of having a > > > > > speakup.map.c. I used a portion of Shanes patch for the 2.2.x tree, > > > > > so thank you very much Shane. > > > > > > > > > > I would appreciate if people would check out the latest version and > > > > > make sure it all works okay. It works for me with the 2.4.9ac4 and > > > > > 2.2.19 kernels. > > > > > > > > > > Kirk > > > > > > > > > > _______________________________________________ > > > > > Speakup mailing list > > > > > Speakup at braille.uwo.ca > > > > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > > > > > > > > > > > > > > > > > > > _______________________________________________ > > > > Speakup mailing list > > > > Speakup at braille.uwo.ca > > > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > > > > > > > > > > _______________________________________________ > > > Speakup mailing list > > > Speakup at braille.uwo.ca > > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > _______________________________________________ > > Speakup mailing list > > Speakup at braille.uwo.ca > > http://speech.braille.uwo.ca/mailman/listinfo/speakup > > > > > _______________________________________________ > Speakup mailing list > Speakup at braille.uwo.ca > http://speech.braille.uwo.ca/mailman/listinfo/speakup
