Hey
On Tue, Jul 31, 2018 at 11:59:13AM -0700, Matthias Kaehlcke wrote:
> The documentation claims that the 'reg' property consists of two values,
> the SPMI address and the length of the controller's registers. However
> the SPMI bus to which it is added specifies "#size-cells = <0>;". Remove
> the controller register length from the documentation of the field and the
> example.
queuing this for next merge window. Applied up to patch 3. both
dt changes go via your arch tree and you can add my ack on them.
Acked-by: Eduardo Valentin <edubezval@xxxxxxxxx>
>
> Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
> Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>
> ---
> Changes in v6:
> - patch added to the series
> ---
> .../devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt | 5 ++---
> 1 file changed, 2 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
> index 290ec06fa33a..86fb41fe772f 100644
> --- a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
> +++ b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
> @@ -6,8 +6,7 @@ interrupt signal and status register to identify high PMIC die temperature.
>
> Required properties:
> - compatible: Should contain "qcom,spmi-temp-alarm".
> -- reg: Specifies the SPMI address and length of the controller's
> - registers.
> +- reg: Specifies the SPMI address.
> - interrupts: PMIC temperature alarm interrupt.
> - #thermal-sensor-cells: Should be 0. See thermal.txt for a description.
>
> @@ -20,7 +19,7 @@ Example:
>
> pm8941_temp: thermal-alarm@2400 {
> compatible = "qcom,spmi-temp-alarm";
> - reg = <0x2400 0x100>;
> + reg = <0x2400>;
> interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
> #thermal-sensor-cells = <0>;
>
> --
> 2.18.0.345.g5c9ce644c3-goog
>
