If ->iobase is set the default will be UPIO_PORT for ->iotype after
the uart_read_and_validate_port_properties() call. Hence no need
to assign that explicitly. Otherwise it will be UPIO_MEM.
Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
---
drivers/tty/serial/8250/8250_pnp.c | 10 ----------
1 file changed, 10 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_pnp.c b/drivers/tty/serial/8250/8250_pnp.c
index 7c06ae79d8e2..7a837fdf9df1 100644
--- a/drivers/tty/serial/8250/8250_pnp.c
+++ b/drivers/tty/serial/8250/8250_pnp.c
@@ -436,7 +436,6 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
{
struct uart_8250_port uart, *port;
int ret, flags = dev_id->driver_data;
- unsigned char iotype;
long line;
if (flags & UNKNOWN_DEV) {
@@ -448,14 +447,11 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
memset(&uart, 0, sizeof(uart));
if ((flags & CIR_PORT) && pnp_port_valid(dev, 2)) {
uart.port.iobase = pnp_port_start(dev, 2);
- iotype = UPIO_PORT;
} else if (pnp_port_valid(dev, 0)) {
uart.port.iobase = pnp_port_start(dev, 0);
- iotype = UPIO_PORT;
} else if (pnp_mem_valid(dev, 0)) {
uart.port.mapbase = pnp_mem_start(dev, 0);
uart.port.mapsize = pnp_mem_len(dev, 0);
- iotype = UPIO_MEM;
uart.port.flags = UPF_IOREMAP;
} else
return -ENODEV;
@@ -471,12 +467,6 @@ serial_pnp_probe(struct pnp_dev *dev, const struct pnp_device_id *dev_id)
if (ret)
return ret;
- /*
- * The previous call may not set iotype correctly when reg-io-width
- * property is absent and it doesn't support IO port resource.
- */
- uart.port.iotype = iotype;
-
if (flags & CIR_PORT) {
uart.port.flags |= UPF_FIXED_PORT | UPF_FIXED_TYPE;
uart.port.type = PORT_8250_CIR;
--
2.43.0.rc1.1336.g36b5255a03ac
