On 10.12.2024 6:06 AM, Viken Dadhaniya wrote:
>
>
> On 12/5/2024 9:29 PM, Konrad Dybcio wrote:
>> On 4.12.2024 4:03 PM, Viken Dadhaniya wrote:
>>> In Qualcomm SoCs, firmware loading for Serial Engines (SE) in the QUP
>>> hardware has traditionally been managed by TrustZone (TZ). This setup
>>> handled Serial Engines(SE) assignments and access control permissions,
>>> ensuring a high level of security but limiting flexibility and
>>> accessibility.
>>> This limitation poses a significant challenge for developers who need more
>>> flexibility to enable any protocol on any of the SEs within the QUP
>>> hardware.
>>> To address this, we are introducing a change that opens the firmware
>>> loading mechanism to the Linux environment. This enhancement increases
>>> flexibility and allows for more streamlined and efficient management. We
>>> can now handle SE assignments and access control permissions directly
>>> within Linux, eliminating the dependency on TZ.
>>> We propose an alternative method for firmware loading and SE
>>> ownership/transfer mode configuration based on device tree configuration.
>>> This method does not rely on other execution environments, making it
>>> accessible to all developers.
>>> For SEs used prior to the kernel, their firmware will be loaded by the
>>> respective image drivers (e.g., Debug UART, Secure or trusted SE).
>>> Additionally, the GSI firmware, which is common to all SEs per QUPV3 core,
>>> will not be loaded by Linux driver but TZ only. At the kernel level, only
>>> the SE protocol driver should load the respective protocol firmware.
>>
>> I think this is a great opportunity to rethink the SE node in general.
>>
>> Currently, for each supported protocol, we create a new node that
>> differs in (possibly) interconnects and pinctrl states. These are really
>> defined per-SE however and we can programmatically determine which ones
>> are relevant.
>>
>> With the growing number of protocols supported, we would have to add
>> 20+ nodes in some cases for each one of them. I think a good one would
>> look like:
>>
>> geni_se10: serial-engine@abcdef {
>> compatible = "qcom,geni-se";
>>
>> reg
>> clocks
>> power-domains
>> interconnects
>> ...
>>
>> status
>>
>> geni_se10_i2c: i2c {
>> // i2c-controller.yaml
>> };
>>
>> geni_se10_spi: spi {
>> // spi-controller.yaml
>> };
>>
>> ...
>> }
>>
>> Or maybe even get rid of the subnodes and restrict that to a single
>> se-protocol = <SE_PROTOCOL_xyz> property, if the bindings folks agree.
>>
>> We could extend the DMA APIs to dynamically determine the protocol
>> ID and get rid of hardcoding it.
>>
>> And then we could spawn an instance of the spi, i2c, etc. driver from
>> the GENI SE driver.
>>
>> Konrad
>
> Thanks for the advice.
> The above design suggested by you may add more code change into protocol driver as well as common driver.
> I am really interested to discuss more options and come to better design. let me discuss with you on this.
> Also do you think we can push the re-design of DTSI nodes as separate change instead of clubbing with this FW load change ?
Sure, the firmware loading support itself is a separate change.
I simply used this thread as an opportunity to talk about a future
cleanup.
Konrad
